Ice Maker User Manual HI6LMK www.HaierAmerica.com Model # HI6LMK Issue Date: April 2013 120 V, 60 Hz Made in China Haier America New York, NY 10018 ©2013 Haier America Trading, LLC.
TABLE OF CONTENTS SAFETY INFORMATION Important Safety Instruc ons 3 SET UP & CARE Supplies Required for Installa on 4 Tools Required for Installa on 4 Parts Included 4 Installa on Instruc ons 5‐8 Water Supply Connec on 9 Ice Maker Opera on 10 Tips & Care 10 Normal Opera ng Sounds 10 TROUBLESHOOTING & WARRANTY Ice Maker Fill Adjustment 11 Customer Service 11 Troubleshoo ng 12 Limited Warranty 13 PRODUCT REGISTRATION Thank you for purchasing our Haier product.
IMPORTANT SAFETY INSTRUCTIONS ! WARNING TO AVOID ELECTRICAL SHOCK, WHICH CAN CAUSE DEATH OR SEVERE PERSONAL INJURY, DISCONNECT THE POWER SUPPLY BEFORE CONNECTING A WATER SUPPLY LINE TO THE REFRIGERATOR. ! WARNING DO NOT PLACE FINGERS OR HAND ON THE AUTOMATIC ICE MAKING MECHANISM WHILE THE REFRIGERATOR IS PLUGGED IN. THIS WILL HELP PROTECT YOU FROM POSSIBLE INJURY AS WELL AS PREVENT INTERFERENCE WITH MOVING PARTS OF THE EJECTOR MECHANISM AND THE HEATING ELEMENT THAT RELEASES THE CUBES.
SUPPLIES REQUIRED FOR INSTALLATION LIMITED WARRANTY The following items are required to install the ice maker. In‐Home Service ‐ What is covered and for how long? ¼‐inch copper supply line with shut off valve. This warranty covers all defects in workmanship or materials of the automa c ice maker for a period of: ¼‐inch brass compression nut and ferrule (sleeve).
INSTALLATION INSTRUCTIONS TROUBLESHOOTING PROBLEM CAUSE/SOLUTION 1. Move refrigerator away from wall and unplug. 2. Remove freezer shelf by li ing up and sliding it out of freezer compartment. Ensure that refrigerator is plugged in to power source Freezer Shelf Wire control arm is fully raised. See Page 9. Check that ice maker is plugged into electrical socket in rear of freezer compartment. See Pages 5‐6. No ice produced Water supply is turned off or disconnected.
INSTALLATION INSTRUCTIONS CONT. 5. Posi on ice maker harness in ice maker hook as shown below: Ice Maker Harness ICE MAKER FILL ADJUSTMENT THESE INSTRUCTIONS SHOULD ONLY BE USED IF THE HOME HAS UNUSUALLY LOW WATER PRESSURE THAT RESULTS IN LOW ICE PRODUCTION OR SMALL ICE CUBE SIZE. CHANGES TO HOME PLUMBING COULD AFFECT ICE MAKER FILL AMOUNT AND RESULT IN OVERFLOWED WATER IN THE FREEZER COMPARTMENT.
ICE MAKER OPERATION NOTE: It takes approximately 24 hours for the ice maker to produce ice. New plumbing may cause ice discolora on and poor flavor. Discard ice made in the first 24 hours. To stop the ice maker, li the wire arm un l it clicks and locks in the OFF (raised) posi on. The ice maker turns OFF automa cally when the ice container is full. If your model has an adjustable freezer shelf, place the shelf so that when the ice container is full, the ice will hit the wire control arm.
INSTALLATION INSTRUCTIONS CONT. WATER SUPPLY CONNECTION 13. Re‐install freezer shelf on lowest rail as shown and place ice bucket under the ice maker. Raise wire control arm on ice maker to OFF posi on. Wire Control Arm ! WARNING This water supply installa on is not covered under warranty by the refrigerator or ice maker manufacturer(s). Follow these instruc ons carefully to minimize the risk of expensive water damage.