Refrigerator Service Manual

Hums from a fully enclosed aggregate unit is the sound caused by

overload indicating that the motor cannot be started normally ,meanwhile ,a

clattering sound can be heard from inside the start relay ,which is produced

because the start contacts cannot be released normally .A whistling sound

is caused by the high pressure gas flowing out of the crack of the pressure

tube inside the compressor ,and clucks are the sound of striking after the

suspended spring inside the compressor has broken .

During the normal operation of compressor ,a slight and uniform hum

sound due to undulation of electric current can be heard generally ,this is a

normal phenomenon .However ,if it sounds like “tong ,tong …”,i.e., an

impact sound inside the compressor ,this means that a large quantity of wet

vapour of refrigerant or refrigerating oil has come into the compressor

cylinder ;if it sounds like “dang ,dang…”, a striking sound of metal parts

inside the compressor ,this means that some moving parts have loosened

(note to differentiate this sound from those formed during starting or

stopping the compressor).

b) Listen to the sound caused by the flowing of gas in the evaporator

Open the refrigerator door while the compressor is in operation ,incline

your ear and listen attentively the gas flow sound inside the evaporator .If it

sounds like gentle whistling accompanied by a sound similar to water

flowing ,this is the sound produced by the normal circulation of refrigerant

within the evaporator .In case only the gas flowing sound can be heard and

there is no water flowing sound ,this indicates that the refrigerant has

already percolated .If neither the flowing sound nor the gas sounds from

the evaporator can be heard ,this means that the filter or capillary has been

clogged .

3)Touch and Feel

a) Feel the compressor when running ,its temperature should be

generally less than 90℃ in the normal state (it may exceed 90℃ in case

of running for a longer period of time ).

b) After the compressor has operated normally for 5~10 minutes ,

ouch and feel the condenser ,the temperature of its upper part should be

higher than that of its lower part (or its right part is hotter than its left

part ,depending on the type of condenser coil ),this indicates that the

refrigerant is circulating . If the condenser is not hot ,this means the

leakage of refrigerant .In case the condenser radiates heat for only several

minutes and then cools down ,this means that the filter and capillary have

been clogged .As for the forced air cooling condenser ,hot air will be blown

out of it ;this means that the system is out of order .

c) Feel the filter’s temperature .During the normal operation of

refrigerating system ,the temperature on the filter’s surface should be a

little higher than the ambient temperature ;if you touch it with your

hand ,you will have a sense of slight heat .In case dew condensation

appears due to the fact that its temperature is obviously lower than the

Maintenance Service and Trouble Shooting