Full Automatic Washing Machine User's manual This manual is for HWM80-0566 Please read this manual carefully before using. Retain it for future reference.
CONTENTS Names of the parts 1 Safety precautions 2 Installation and adjustment 4 Install the water inlet hose 6 Preparation before using 8 Put 9 in the laundries Usage of the detergent 9 Close the top lid 9 Use the operation buttons 10 Finish washing 13 Disposal after washing 14 Trouble shooting answer to question 15 Packing list specifcation 16
Packing list Names of the parts Quantity Name One User's manual Water inlet valve Top lid component Component of the water inlet hose Control pannel The end connecting to the washing machine One Water absorption cushion Filter cover Detergent box Balance ring Jointer connecting the water inlet hose and the water faucet The end connecting to the water inlet hose jointer Power cord Lint filter Inner tub Handle Pulsater Adjustable leg film Front control board Adjustable leg Back cover Dr
Safety precautions Please plug the power plug on special receptacle. Be sure to use three-pins power receptacle. Ensure that the earthing prong of the power receptacle is earthed reliably. Use leakage protector if possible. The washing machine must be positioned so that the plug is accessible. Be sure to pull the plug off and close the water faucet in following cases: power failure, delivering the machine, setting the machine idle or cleaning the machine. Do not plug or pull the power plug with wet hand.
Safety precautions Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Clean the detergent box and set it on the control panel seat. 1.The method of dismantle: Push it up aslant and gently. 2.The method of install : install it upwards and aslant and push it in . Dismantle Install Do not put hand into the rotating tub.
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. 4 Push the " water level" button, select suitable water level WATER LEVEL Install the bottom plate After you open the package, please lean the washing machine gently down on soft items ( like the towel cloth, blanket, etc. ).
b Steps of using the operation buttons and description of the steps How to change the direction of the drain hose 1.Dismantle the rear cover of the washing machine. 2.Put down the drain hose Take off the drain hose frame as indicated in Figure 1.Take the drain hose into the cabinet then nip the drain fixing clamp to make it deviated from the clip the other hand is used to put down the drain bushing as indicated in Figure 2 3. 4 3.
Install the water inlet hose Confirm the water faucet "Start/pause" button Water faucet,suitable Water faucet,not suitable Outlet end surface After the power is switched on, press it to start the machine During working, push it to pause. During pause, push this button to restart and go on working "Power" button Push the "power" button to switch on the power. Under power-on mode, push it to switch off the power. Push the "power" button to switch on the power.
5 Use the operation buttons a Connection between the water inlet hose and the washer Description of operation button 1.Do not take off the water absorption cushion. Please check if the cushion is dropped or damaged before each usage. If it happens please contact our after-sale department immediately.
1 Preparation before washing 2.Put in the laundries The capacity of washing of the machine refer to the largest weight of the standard laundries under dry condition that can be washed in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The largest capacity of this machine is 4.5kg. The thickness ,size , type of the cloth will influence the actual washing capacity.
