by yourself.
Remove Install The applicance water pressure is 0.03MPa-1.0MPa (when water temperature is 55 ,the water inlet pressure of hot water shall not exceed 0.4MPa). The maximum mass of dry cloth to be used in the appliance is 6kg for HWMSP60, 7kg for HWMSP70. This product has been designed for use in a normal domestic (residential) environment. This product is not designed for any commercial use (whatsoever). Any commercial use by a customer will affect this product’s Manufacturer’s Warranty.
The purpose of the bottom plate is to suppress noise from the washing machine during operation. Steps: 1.Lay the washer on its back,on a non-abrasive surface. 2.Insert the bottom plate to the bottom of the machine. 3.Use a screwdriver to tighten the screw(in accessory bag) securing the plate to bottom of the washer. 4.Once the screw is tight and the plate is secure,return the washer to its standing position.
Connect drain hose hook on to the outside of drainage hose. To guide the drain hose over the tub or standpipe, the bracket MUST be fitted to the drain hose.
3 2 1
all cycles If a manufacture specifies only the use of a low-sudsing or high-efficiency type detergent, then detergent for drum type machines shall be used irrespective of the type of machine under test. Otherwise the detergent type to be used shall be chosen according to the type of clothes washing machine under test, as follows.
