Specification HWT10MW2 . 350W 300W 45kg 52kg W 610 D 620 H 1045 Rated Washing capacity TOP LOAD FULLY AUTOMATIC WASHING MACHINE OWNER’S MANUAL MODEL: HWT10MW2 10kg Please read this manual carefully before operating your washing machine and retain it for future reference.
Location Safety precautions Installation & Adjustment Warranty card Loading your laundry Detergent usage guide Operation & Wash cycles Bracket One On The Drain hose
Product overview Top lid component Detergent box Back panel Outer tub cover Water absorption gasket Inner tub Filter frame Cold water inlet valve Hot water inlet valve Control pannel seat Hook Pulsator Power cord Cabinet Back cover Base frame Drain hose joint Adjustable foot(2pieces) Screw cover Fixed foot(2 pieces) an injury to the
Warning A separate, earthed power socket is required for the power supply. Hold the plug-NOT the electric cable-when unplugging the washing machine. Do not insert or remove the power plug with wet hands. The power plug should be accessible after the machine installation. if the machine Ensure the plug is removed and the taps turned off in the followng cases: Power failure, cleaning, moving, installation and when not in use. by yourself. The machine does not drain or drain slowly.
Clean the detergent box and set it on the control panel seat. 1.Dismantle: Pull the detergent box, then hold two sides with hands.Press downwards and pull meanwhile, then it can be pulled out. . 2.Clean: Use a brush and duster cloth to clean it, then flush it with water. 3.Install : Install it upwards and push it in. The lint filter must be used during washing. It must be cleaned in time after each using. Lint filter: 1.
used， ，close the lid and press the “start/pause”,the machine will run Child Lock and wall should be at least 20mm Set the desired washing program,after setting, press the “Start/Pause” button,and washing machine begin to run. Then hold the “Progress” button and “Delay” button at the same time for more than 3 seconds，you will hear three beep sound，digital tube display “CL”,and the child lock will activate. All of the buttons are locked, and will no function.
Spin During Express,Wool, Duvet , Drum Clean and Anti Crease cycles,these settings cannot be changed and buttons will not function, as machine will only follow pre-programmed settings. Attention: Even there’s no water in the tub, the spinning will start after a certain period back side of the cabinet, and fasten with drain hose clamp(provided). , the bracket Bracket clamp For the “Cotton” and “Eco”cycles the machine will run a Fuzzy Logic program not Temp 800-1200 “Start/Pause” button is pushed.
F Water Temp Water Temp 1 During Wool and Duvet cycles, the “Hot”,“Warm”,“Max” water temperature cannot be chosen. During Drum Clean cycle, the “Cold”,“Warm”,“Max” water temperature cannot be chosen. During Anti Crease cycle, the “Hot”,“Max” water temperature cannot be chosen.
Soak Time Rinse Spin Time You may change the Soak time，Rinse and Spin time, except Express, Wool, Anti Crease. C Progress You may change the Progress,except Express,Wool, Duvet ,Drum Clean and Anti Crease cycles are selected. 800mm≤h≤1200mm D Check the following before washing E During the Eco and Cotton programs the washing machine will detect the size Mid,High or Max.
Mid low washing powder is used Liquid detergent box H F E B B B C D A Adding washing power Washing powder inlet Softener inlet Detergent box How to use liquid detergent Put the liquid detergent box on the right of the detergent box. See the above figure. Before washing put the liquid detergent into the liquid detergent box directly as indicated the above figure. The usage and dose of the liquid detergent as per the specifications of liquid detergent.
