L32D1120 L32F1120
Contents Safety and warnings.......................................................................................2-3 Introduction..................................................................................................4 Stand installation guide..................................................................................5 Installation....................................................................................................6-9 Remote Control...........................................
SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTION 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this Television near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings, install in accordance with the instructions. 8) Do not install near any heat sources such as radiations, heat registers, stoves, or other Television (including amplifiers) that produce heat.
SAFETY AND WARNINGS High voltages are used in the operation of this television receiver. Do not open the cabinet. Refer servicing to qualified service personnel. Never stand on, lean on, or suddenly push the television or its stand. You should pay special attention to children. Serious injury may result if it falls. To prevent fire or electrical shock hazard, do not expose the television receiver to rain or moisture. Do not place your television on an unstable cart, stand, shelf or table.
INTRODUCTION Main features Accessories Integrated ATSC TV tuner for HDTV broadcast reception High brightness provides a vivid and brilliant picture Deeper blacks and brighter whites with high contrast Wide Screen aspect ratio (16:9) for a complete home theater experience HDMI input for true digital connection VGA port for connection to PC Built-in stereo speaker system Full-function Remote Control Power Cable.....................................1 Infrared Remote Control....................
STAND INSTALLATION GUIDE This STAND INSTALLATION GUIDE is provided to help you easily install the stand. Please carefully follow Steps 1 through 3. Open the box and find the parts Open the box and find the following parts. - Stand x1 pc - Screws x 4 pcs Screws Packing Stand TV Stand Packing Place the Stand on the TV 2. Place the Stand on the TV as shown below. 1. Place the TV face down on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any damage to the TV.
INSTALLATION Side panel Front panel R 9 L AV2 8 Video 7 6 USB 3 SOURCE MENU CH+ 1 3 CHVOL+ 2 VOLSTANDBY 30 1: Remote control sensor. 2: Indicator LED: GREEN RED 3: 1 2 4 5 30 1. SOURCE: Display the input source menu. 2. MENU: Display the main MENU. 3. CH+/CH-: In TV mode, press "CH+" or "CH-" to change the channel up and down. In MENU mode, press "CH+" or "CH-" to select items in standby mode, press "CH+" or "CH-" to turn on the TV. 4. VOL+/VOL-: Adjust sound level.
INSTALLATION PC STEPS: Be sure both the TV and computer are powered off. 1. Connect a VGA and audio cable. 2. Connect the power cord. 3. Turn on the TV and switch to VGA mode. 4. Turn on the PC. HDMI 1 HDMI 2 VGA INPUT Pr COMPONENT Pb INPUT AC INPUT 100-240V~50/60Hz AV1 AUDIO INPUT Y L HEADPHONE PC AUDIO INPUT COAXIAL RF INPUT R PRESET MODE RESOLUTION 1 V.Freq.(Hz) H.Freq.(KHz) 640*480 60 31.47 2 800*600 60 37.88 3 1024*768 1280*1024 60 60 48.36 63.
INSTALLATION ANTENNA Note: Aerial connections:IEC(female). Input impendance:75 unbalanced.
INSTALLATION AV EQUIPMENT There are two HDMI ports located on the back of your TV. You can connect a Blu-ray player, DVD player, or other video equipment through these ports. There is one component (Y, Pb, Pr) and two composite (AV) video input located on the back of your TV. You can connect a VCR, cable box, or other video equipment to these jacks. Please see the diagram below. You may also need to refer to the owner's manual of the device that you are trying to connect.
REMOTE CONTROL The remote control cannot be operated unless the batteries are properly loaded. When using the remote control, aim it at the remote control sensor on the TV. Function introduction 1.Press to turn on and off the TV. 2.Press repeatedly to cycle through the available picture modes. 3.Press to change the aspect ratio. 4.Select a closed caption option. 5.Show the input source. 6.Press to open the on-screen menu. 7. Press CH+ or CH- to go to the next or previous channel in the channel list.
OPERATION CH+ VOL+ ENTER VOL- CH- -11-
OPERATION -12-
OPERATION -13-
OPERATION -14-
OPERATION -15-
OPERATION -16-
OPERATION -17-
OPERATION -18-
OPERATION -19-
OPERATION -20-
OPERATION -21-
OPERATION REPEAT -22-
TROUBLE SHOOTING Trouble phenomenon Symptom Inspection Check Picture Audio Snow Noise antenna position, direction or connection Ghost Normal audio antenna position, direction or connection Interference Noise electronic equipment,car/ motorcycle,fluorescent light Mute Volume (check if mute is activated or if the audio system connections are not correct) Normal Picture No picture No color Picture breaking up Mute Power cord is not inserted Power switch is not opened Contrast and brightness/
WARRANTY -24-
