LED LCD TV OWNER' S MANUAL MODEL: L E 2 8 M 6 0 0 Please READ this manual carefully before operating your TV, and retain it for future reference
Contents 1、 Safety and warnings..........................................................................................................2-3 2、 Introduction.....................................................................................................................4 3、 Installation...................................................................................................................... 5-8 4、 Remote Controller..............................................................................
SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTION 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings, install in accordance with the instructions. 8) Do not install near any heat sources such as radiations, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
SAFETY AND WARNINGS High voltages are used in the operation of this television receiver. Do not remove the cabinet back from your set. Refer servicing to qualified service personnel. Never stand on, lean on, or suddenly push the television or its stand. You should pay special attention to children. Serious injury may result if it falls. To prevent fire or electrical shock hazard, do not expose the television receiver to rain or moisture.
INTRODUCTION Accessories Main features ① Used as Television, display terminal, PC display; Infrared Remote Controller............ 1 ② High luminance, wide viewing angle; Battery(AAA)...............................2 ③ Can store 200 TV programs; User’ s M anual...............................1 ④ HDMI interface; MHL Cable . . ................................ 1 HDMI2/MHL: Connect the devices which can support MHL function; also function as HDMI input socket. MHL Connector . . .........................
INSTALLATION KEYBOARD Front panel 4 SOURCE 1 MENU 2 CH+ 3 CHVOL+ 3 4 1 VOL- 2 STANDBY 30 USB 5 30 VGA SLEEP ASPECT YPbPr TV 1.SOURCE: Display the input source menu. 2.MENU: Display main MENU. 3.CH+/CHIn TV mode,press“CH+”or“CH-”to change the channel up and down. In MENU mode, press “CH+”or“CH-”to select items. 4.VOL+/VOLAdjust sound level. In MENU mode, press“VOL+”or“VOL-”to adjust the item that you selected. 5. STANDBY Press this button to turn the unit ON from STANDBY mode.
INSTALLATION ANTENNA Note: Aerial connections: IEC(female). Input impendance: 75 unbalanced. PC STEPS: 8 Be sure both the TV and computer are Power off. 1.Connect VGA and audio cable 2.Connect power cord 3.Power on the TV, switch to PC mode 4.Power on the PC This sequence is very important.
INSTALLATION PRESET MODE (PC) RESOLUTION V.Freq.(Hz) H.Freq.(KHz) 800*600 60 37.88 2 1024*768 60 48.36 3 1360*768 60 47.7 H.Freq.(KHz) 1 NOTE: PC V.Freq.(Hz) not more than 60Hz. PRESET MODE (HDMI) RESOLUTION V.Freq.(Hz) 1 800*600 60 37.88 2 1024*768 60 48.36 3 1360*768 60 47.7 4 1280*768 60 47.3 5 1920*1080 60 67.
INSTALLATION AV EQUIPMENT This TV provides one group of AV, one group of YPbPr for convenient connection to VCR, DVD or other video equipment. Please refer to the owner's manual of the equipment to be connected as well. You can use the input terminals on TV set rear as follows.
REMOTE CONTROLLER The remote control cannot be operated unless the batteries are properly loaded inserted. When using the remote control, aim it at the remote control sensor on the TV. Function introduction 1 16 28 17 2 18 3 4 SLEEP ASPECT MHL TV 6 19 20 5 USB VGA 21 7 22 8 23 9 10 11 24 CH.LIST 12 S.M 13 CH VOL 25 P.M 26 14 15 DISPLAY 27 1. POWER: Press to turn on and off the TV. 2: ◄◄: In USB mode, used as reverse key. 3: ►►: In USB mode, used as forword key. 4.
TV OPERATION 1. CHANNEL MENU The first item of the MENU is channel menu ( for TV source only). You can search channels and edit programs here. Press to move, press OK button to confirm, and press to adjust. CHANNEL Programme Edit Auto Tuning Delete OK Rename Move OK PICTURE Sound System Manual Tuning SOUND Programme Edit Delete Software Update(USB) Skip MENU Delete TIME Press to choose the program. Press red button, the program will delete.
TV OPERATION 3. SOUND MENU The third item of the MENU is the SOUND MENU. You can adjust the sound effect here such as treble, bass, balance etc. Press ▼▲ to move, press OK button to confirm, and press◀▶ to adjust. CHANNEL NOTE: Restore factory default will clear all the programs and Reset all the settings to default value. 6. USB FUNCTION You must enter the Source menu first,then choice the USB and press OK button,the USB menu will appear.
TV OPERATION Press ◀▶ to select the function icon, press OK button to Haier Innovation Life confirm the function. Press ▼ or EXIT button to exit the control bar. NOTE: You can adjust the audio track, subtitle, or program in return Return C the Info menu while Playing the video file. Choose the Info icon and press OK can display the Info EXIT Back OK Move Select MENU.
TV OPERATION Hotel Mode: Please press source key first,and then press number key “1001” to enter into Hotel Mode. Hotel Mode Operation Hotel Mode Operation Panel Key Lock Max Volume Start Source Start Channel Setup Menu Display Source Key Lock Save To USB Load Volume Default Capture OFF OFF 100 TV 1 Yes Yes 0 Off Hotel Mode Operation : Set Hotel mode on/off. Panel key lock : Keypad will be locked, when Key Lock mode is on. Max volume: Set max volume limitted.
MHL USER GUIDE MHL user guide: 1: Turn on the TV, and unlock the phone screen. 2: Connect one end of the MHL cable to the TV "MHL" port. 3: Connect other end of MHL cable to Mini USB interface of mobile phone HDMI2/MHL MHL Port If your mobile phone is Samsung GALSXY SIII or GALAXY NOTE II, please use inverter from the attachment to connect MHL cable and mobile phone. Other brand can connect with MHL cable directly. 4: Press “ MHL ” on the remote control to switch the TV to the MHL mode.
TROUBLE SHOOTING Trouble phenomenon Picture Audio Snow Ghost Noise Normal audio Interfere Normal Picture No picture Inspection antenna position, direction or connection antenna position, direction or connection Noise electronic equipment,car/ motorcycle,fluorescent light Mute Volume(inspect wether the mute function on the remote control are started , or audio system are correct or not) Mute Power cord is not inserted Power switch is not opened Contrast and brightness/volume setup Press stan