User Manual

3 Operation Instruction
3.1 Outline
Admin: code (fingerprint, card or remote control cannot be used as admin)
User: card, code(6-10digits), fingerprint(fingerprint version), remote control(remote control version)
User Capacity: HFAD6300-R, 1 admin code, 100 codes, 800 cards, 120 remote controls
HFAD6300-L, 1 admin code, 100 codes, 800 cards,
HFAD6300-FR, 1 admin code, 100 codes, 150 fingerprints, 120 remote controls
HFAD6300-F, 1 admin code, 100 codes, 150 fingerprints,
3.2 System Initialization
Default admin code is “123456”. You must change the default admin code to add user.
Initialization：

You can press “*” “#”, and then input the admin code to enter to system setting.
3.3 Operations
Press “*” “
#
” Admin Code “
#
” to enter the following menu
Set Admin Code
Set User Code:
Set Card user:
Set remote control(For remote control version):
Set fingerprint(For fingerprint version):
(Tips: you can add many users at the same time, for example, when you just added a code user,
you can press the unlock button on remote control to add a remote user, or put a finger on
fingerprint sensor to add a fingerprint, or input anther code to add another code user )
Press RST button for
6 seconds
System initialization, recover to factory state, admin code
back to “123456”
“*”+“#”
Admin Code
+
#
2
Press the unlock button on remote
controller
“*”+“#”
Admin code
+
#
1
New Admin Code
+
#
“*”+“#”
Admin Code
+
#
2
New User Code
+
#
“*”+“#”
Admin Code
+
#
2
put one finger on fingerprint sensor
twice
“*”+“#”
Admin Code
+
#
2
Put a card close to numbers on keypad
4