Installation Guide

ManualsBrandsHair Care Hideaway ManualsBathAmerican Hideaway 15 in. W Wall Cabinet with Concealed Hair Care Organizational in White

1 | P a g e

Instructions To Install Your New Hair Care Organization Cabinet

Tools you’ll need:

 Stud finder

 Drywall saw

 Level

 Screwdriver

 Drill and a #6 drill bit

Note:

If replacing an existing medicine cabinet remove the old cabinet and skip to step 6.

It is recommended and safer to remove door before attempting to install cabinet.

Step 1

Decide if you need to install the HCH cabinet on the left or right side of your vanity, all cabinets are

shipped standard with a right hand door swing. If you need a left door swing, simply remove door buy

removing screws from cabinet side of the hinges, then rotate the door 180 degrees and reinstall them

on the opposite side of the cabinet. This will make a left hand door swing.

Note If not installing with an electric plug, make sure to choose the side of your vanity that has a GFI

plug. Mount the HCH cabinet as close to your GFI as possible.

Step 2

After you decide your placement is on the left or right side of the vanity use the stud finder to locate

the studs in the wall, all ways start in the corner of the wall and pan out. Once the studs are located

mark the inner stud and outer stud, this span should be 14.5”inbetween the studs.

At this location check both sides of the walls for obstructions like plumbing pipes, vents or electrical

wires that may interfere with the installation of the cabinet and the cord tubes that go down inside the

wall. If no obstructions you can Plan on placing your Hair Care cabinet between these studs? In some

cases electric wires can be moved to allow the HCH tubes to slide down beside the wiring.

Summary of content (4 pages)

PAGE 1
Instructions To Install Your New Hair Care Organization Cabinet Tools you’ll need:      Stud finder Drywall saw Level Screwdriver Drill and a #6 drill bit Note: If replacing an existing medicine cabinet remove the old cabinet and skip to step 6. It is recommended and safer to remove door before attempting to install cabinet. Step 1 Decide if you need to install the HCH cabinet on the left or right side of your vanity, all cabinets are shipped standard with a right hand door swing.
PAGE 2
PLEASE NOTE: in some rare instances, the location where you want to mount the HCH cabinet will not land easily between two studs and a stud may be in the way. In this instance, you simply need to cut the obstructing stud and frame the opening with 2x4s to give the cabinet a secure mount. Remember not to frame the bottom. Here is a link to an article on an installation that requires cutting a stud: http://www.thisoldhouse.com/toh/how-to/intro/0,,20048437,00.
PAGE 3
Step 9 Attaching weights to Appliances cords See (Pic 2, 6.) Install a roller-weight by unclipping the roller sliding it downward, then insert the cord and replace the roller, Then insert the roller assembly and the cord in the selected tube, allow the weighted roller to pull cord down in the tube to its full extension, It should slide up and down the tube freely without any resistant.
PAGE 4
PIC 1 Bottom Tube sections 3 parts Pic 4 Tube install 4 | P a g ePic 7 Cord illustration PIC 2 Rollers Pic 5 Tube Cap Pic 8 Cabinet illustration Pic 3 Center Tub Pic 6 Roller Weight Pic 9 Plug covers blank