Installation Guide

INSTALLATION INSTRUCTIONS:
1. Turn OFF power at switch and fuse box or
circuit breaker.
2. Remove existing trim installed in recessed luminaire
(if necessary).
3. If applicable, slide lamp holder bracket to its upward
maximum position. If the lamp holder bracket is less than
4.5 inches from the bottom edge of the xture enclosure,
the lamp holder bracket must be removed.
4. If necessary, remove the lamp holder mounting bracket
(see FIG.2) and the lamp holder from the bracket
(see FIG.2).
5. Install adapter into socket (see FIG. 3).
ProLED
®
6" Adjustable Downlight Installation Instructions
®
Halco Lighting Technologies | 2940 Pacic Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone [phone] | Fax [phone] | halcolighting.com | Atlanta | Carlstadt | Cleveland | Houston | Los Angeles | Phoenix
© 2016 Halco Lighting Technologies, LLC. All rights reserved. Halco is a registered trademark of Halco Lighting Technologies. All sizes and specications are subject to change. 06-22-16.
IMPORTANT
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ProLED luminaires must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A QUALIFIED ELECTRICIAN WHO IS
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING - Risk of re or electric shock. ProLED
®
Adjustable Downlight Series installation requires knowledge of the luminaire’s electrical systems. If not
qualied, DO NOT attempt installation. Contact a qualied electrician.
WARNING - Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings.
DO NOT make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING - To prevent wiring damage or abrasion, DO NOT expose wiring to edges of sheet metal or other sharp objects.
WARNING - DO NOT alter, relocate, or remove wiring, lamp holders, power supply, or any other electrical component.
WARNING - This device is not intended for use with emergency exits.
DANGER - RISK OF SHOCK-DISCONNECT POWER BEFORE INSTALLATION
CAUTION: To avoid possible electrical shock, be sure that power supply is turned off at fuse box or circuit breaker before installing or servicing
luminaire.For your safety, read and understand instructions completely before beginning installation.
WARRANTY INFORMATION:
This product is warranted for 5 years from the date of purchase. If this product does not perform to the specications supplied on this package, send
an email or write to the address below for product return and replacement. This replacement is the sole remedy available. Liability for incidental or
consequential damage is expressly excluded. Visit www.halcolighting.com for full warranty details and dimmer compatibility information.
Packaging Contents
Before beginning installation on this product, make sure all parts are present. Compare parts with package contents list and diagram as below. If any
part is missing or damaged, do not attempt to assemble, install or operate this product.
Components Included
A. Medium Base Adapter
B. Retrot Assembly
C. Instruction Sheet
Remove lamp
holder
bracket
(if Necessary)
FIG. 1B Diagram of recessed luminaire FIG. 3
FIG. 1A FIG. 2
Install the
Adapter