Instructions / Assembly

Use Flexible Conduit Only
1. Disconnect power at fuse or circuit breaker before installing or servicing.
2. Do not use outdoors.
3. Do not mount in hazardous locations, or near gas or electric heaters.
4. Do not let power cords touch hot surface.
5. Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized
personnel.
6. Do not use this equipment for other than intended use.
7. All servicing should be performed by a qualified personnel only.
8. After installation is finished, Please charge battery 24hours.
Page 1 of 2
IMPORTANT SAFEGUARDS
INSTALLATION INSTRUCTIONS FOR
LED EMERGENCY LIGHT
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
When using electrical, basic safety precautions should always be followed including the following.
OPERATION
TROUBLE SHOOTING GUIDE
If LED heads or LED indicator does not illuminate, check the following:
1. Check AC supply - verify that unit has 24 hours AC supply.
2. Battery
connection.
3. Discharge the Battery and then charge the battery for 24 hours and retest.
4.
If above trouble shooting hints do not solve the problem, contact factory for assistance.
DUAL VOLTAGE INPUT (120/277V)
SAVE THESE INSTRUCTIONS
MAINTENANCE
Battery have to recharge if product keep in stock over 9 months, detail manual refer “BATTERY STOCK AND RECHARGE
GUIDELINE”.We recommend that the equipment is tested regularly in accordance with local codes. Replace the batteries as
needed if discharge time do not achieve 90 minutes.
Press the test button. The LED heads will turn on and the LED indicator light will turn off.
Release the test switch,So that the LED indicator will turn on and the LED heads will turn off.
Halco Lighting Technologies www.halcolighting.com

Summary of content (2 pages)