Installation Guide

SURFACE MOUNTING
wall mounting. Mount to a recessed octagonal junction box
as follows:
1. Carefully snap out Lens one side at a time from
Housing.
WARNING: To prevent wiring damage or abrasion,
do not expose wiring to edges of sharp objects.
Linear LED WRAP Installation Instructions
Use the appropriate mounting hardware for the
mounting surface.
2. Pull supply wires from Junction Boxthrough Center
Access Hole of Housing as shown in in right Fig. Use
appropriate UL approved wire connectors as required
by code to make electrical splices to
3. Secure Housing to junction box or mount Housing
directly to sturdy surface by using the Drill Locations
4. Once connections are made push all wires in housing.
5. Be careful not to pinch wires. Hook Lens to one side of
Housing and Snap Lens into place.