Installation Guide

© 2016 Halco Lighting Technologies, LLC. All rights reserved. Halco is a registered trademark of Halco Lighting Technologies.
All sizes and specications are subject to change.
Halco Lighting Technologies | 2940 Pacic Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone [phone] | Fax [phone] | halcolighting.com | Atlanta | Carlstadt | Cleveland | Houston | Los Angeles | Phoenix
LED Large Wall Pack Series
Installation Instructions
Models: WP4/CL87BZ50/LED (99917)
WP4/CL120BZ50/LED (99918)
IMPORTANT
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING - Risk of re or electric shock.
WARNING - Make certain power is switched OFF before starting installation or
attempting any maintenance. Consult an electrician if not qualied to
prevent electrical shock.
WARNING - Use silicone caulking on back of housing in contact with wall surface,
to seal against moisture and insects.
Installation steps:
STEP 1: Open the luminaire by loosening the two tamper-proof captive screws on the side and remove the
Glass door assembly.
STEP 2: Prepare the back plate for mounting by drilling or knocking out the appropriate holes.
STEP 3: Line up the back plate in the desired location and mount securely.
STEP 4: If using electrical conduit, remove the screw cap from the desired conduit hole and replace with conduit. Route
the branch circuit wires inside the luminaire. If using a junction box, bring the branch circuit wires through the
rear hole into the luminaire.
STEP 5: Splice the branch circuit power leads to the luminaire power leads, black to black (hot), white to white (neutral),
and green to green (ground).
STEP 6: Replace the glass door assembly using the provided tamper-proof captive screws
IMPORTANT:
To weatherproof your outdoor installation, be sure to seal all holes, conduit plugs, and photo controls in luminaire
housing with silicone caulking.
Application/ Use:
This product is rated for use in wet locations and designed for surface mounting only.
Mount luminaire to an outdoor wet location rated electrical junction box supplied by others.
IMPORTANT SAFETY INFORMATION:
CAUTION: This luminaire must be wired in accordance with the National Electrical Code and applicable local codes and
ordinances. Proper grounding is required to ensure personal safety. Carefully observe grounding procedure
under installation section.
CAUTION: Installation and servicing of this equipment should be performed by qualied personnel only.
CAUTION: Do not mount near gas or electrical heaters.
CAUTION: Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
CAUTION: The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Any
modication or use of non-original components will void the warranty and product liability.
®