Manual

Routine Maintenance ❑
59
CAFSPro User Operation Manual
p/n: 029-0020-75-0
❑ Tighten two
jacking
studs
located at
both ends
of the com-
pressor
mounting
bracket.
9. If the belt
tension is
tighter than
required:
❑ Loosen two
studs
located at
both ends
of the com-
pressor
mounting bracket. Make sure that the two nuts are tight to the bracket.
(See Figure 7-6: ‘Belt Tension Adjustment Bolts.’)
❑ Tighten bolt located in the middle of the compressor mounting bracket.
10. Repeat preceding Steps 2 through 6 to verify that the belt tension is
within the required limits. Readjust accordingly.
11. Reinstall the belt guard and test run the system before returning the unit
to service.
7.7 HOT SHIFT CLUTCH OPTION
(See Figure 7-7: ‘Hot Shift Oil Sight Tube’ on page 60.)
The hot shift clutch oil should be changed every 100 hours of operation or
when the apparatus engine oil is changed.
To change oil...
1. Place a suitable container 12 to 14 ounces under the hot shift front
clutch housing and remove the brass drain plug. (See Figure 7-7: ‘Hot
Shift Oil Sight Tube’ on page 60.)
2. Drain all oil then reinstall the brass drain plug.
Figure 7-6: Belt Tension Adjustment Bolts