Manual

Calibration ❑
61
CAFSPro User Operation Manual
p/n: 029-0020-75-0
8 Calibration
The complete Hale CAFSPro System is tested and calibrated at the factory before
shipment to the installer. Further calibration is not necessary until delivery to the
customer site. Calibration of the system is required ONLY after major repairs or
component changes are required to the Hale CAFSPro Foam System.
The system is designed to permit easy verification of component calibration to
assure accurate operation. The verification process checks component calibration
and allows adjustments to the water flow sensor display readings, allowing for vari-
ations in apparatus piping configurations.
NOTE: The Hale CAFSPro system is calibrated at the factory to U.S. measure-
ments (SCFM, PSI, GALLONS, F
°
, etc.) units.
Each component of the matched system is assigned the same serial number to
ensure the system remains together.
8.1 ENTERING PASSWORDS
Entering a password is accomplished by pressing the ARROW pads in a
sequence. (See Table 8-1: ‘Default Passwords.’)
Table 8-1: Default Passwords
Entering a password is accomplished by
pressing the ARROW pad in a sequence.
(See Table 8-1: ‘Default Passwords.’)
1. Press and hold the DISPLAY pad.
The display shows PASS then clears.
2. While holding the Display (
i ) pad,
press the
 (DRY) or  (WET) pads
in sequence to enter the password.
Figure 8-2: Sample PASS Display
MODE PASSWORD
Enter User Calibration
   
Restore Factory Default Settings
   