Owner manual

Quick Start Guide
(FoamLogix System, Portable Pro Kit)
1. CLOSE all discharge valves.
2. Set the main power switch ON. (See
Figure 1.)
3. Set the throttle to approximately the ¼
position. (See Figure 2.)
4. Start the engine. (See Figure 3 in the
next column.)
(Adjusting the choke may be required
if the engine is cold.)
5. If the pump intake is piped to a water
tank with the water level higher than
the eye of the pump impeller, OPEN
the tank –to–pump valve to flood the
pump inlet.
Otherwise, the pump runs from a draft
condition. Follow the pump
manufacturers operating instructions
for priming the pump.
6. OPEN the desired discharge valve(s).
(See Figure 4.)
Operation
THIS QUICK START GUIDE IS ONLY INTENDED AS A BRIEF OVERVIEW TO THE
OPERATION OF THE FOAMLOGIX 2.1A SYSTEM AND IS NOT INTENDED TO BE
A REPLACEMENT FOR THE INSTALLATION /OPERATION MANUAL (HALE
P/N: 029-0020-74-0) PROVIDED WITH EACH SYSTEM. ALSO AVAILABLE
ON-LINE – WWW.CLASS1.COM.