User's Guide

HUG-SR300 190410 v0.2
TROUBLESHOOTING
If Halio Wireless Range Extender becomes unresponsive with
no LED activity, it has likely lost power.
Check Power
To check power:
1. Check the power supply has not become unplugged or is
not somehow switched off.
2. Check the power wiring has not somehow become
disconnected at the wiring terminals.
3. Use a multi-meter to confirm the voltage being supplied
to the Wireless Range Extender (12 – 48VDC).
If LEDs blink but commands appear unresponsive, it may be
useful to reboot the device using the reset button.
Device Reboot
To reboot the Tint Selector:
1. Remove the cover plate to access the reset button
2. Click the Reset button using a pen or paperclip.
3. LEDs will blink as the device restarts and rejoins the
wireless mesh network.
REGULATORY COMPLIANCE
FCC ID No. 2AJXY-SR300
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter. This equipment complies with the FCC RF
radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of
20cm between the radiator and any part of your body.
Note that changes or modifications not expressly approved by Kinestral
Technologies could void the user's authority to operate the equipment.
IC No. 22717-SR300
This device complies with Industry Canada’s license-exempt RSSs. Operation
is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
The transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter. This equipment complies radiation exposure
limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20cm between the
radiator and any part of your body.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
L'émetteur ne doit pas être co-localisé ou utilisé en conjonction avec une
autre antenne ou un autre émetteur. Cet équipement est conforme aux
limites d'exposition aux radiations définies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé à une distance minimale
de 20 cm entre le radiateur et toute partie de votre corps.
KEY: XXXXXX
MAC : XXXXXXXXXXXX