Owner's manual

HDMI Switch – 4 Input – 1 Output

1. Introduction

1.1General

This User’s Manual applies to Hall Research Model SW-HDMI-4.

This model is a high performance HDMI Switcher capable of switching and boosting 4 independent HDMI

Video+Audio sources to 1 output.

Make selections by using the front panel push buttons, using the IR remote control or by RS232 from an

external controller.

Since HDMI (and DVI) digital signals have cable distance limitations, the SW-HDMI-4 provides the ability to

boost the output signal to drive long HDMI cables to about 50 feet. Furthermore, the unit has built in automatic

equalizers on the inputs so that it can handle long input video cables (to 65 feet).

1.2 Features

• Perfect solution for high-end home-theatre setups

• Use only one connection to your HDMI compatible HDTV

• Equalizes the inputs for losses in the cable to 65 feet

• Auto signal enhancement (Boost) improves video quality over long cables

• Front panel LED indicators for status monitoring

• Supports PC resolutions to 1920x1200 and HD to 1080p

• Includes a simple to use Remote Control

• Plug and play installation – takes minutes to setup

• Bandwidth of 1.65 Gbps (Gigabits/second) for sharp digital image

• HDMI 1.3, HDCP 1.1, and DVI 1.0 Compliant

• Supports 30/36 bit color depth

• Supports High Definition audio – Dolby Digital TrueHD and DTS-HD

• Supports HDMI Cable Locking

2. Installation

2.1 Package Contents

Your package should contain the SW-HDMI-4 unit, a Universal power supply (5 vDC @ 2A), an IEC320 Power

Cord, an IR remote control and a User’s Manual.

3. Configuration & Operation

• Connect all the video sources to the INPUT connectors on the back of the SW-HDMI-4

• Connect the display device to the OUTPUT connector on the back of the SW-HDMI-4

• Connect the Power Supply to the power input on the back of the SW-HDMI-4

• Connect an external controller or PC to the RS232 port on the back of the SW-HDMI-4, if required.

• Press the POWER button on the front of the unit to turn the unit on. The LED next to the button will

always display the power status.

• Press the INPUT button to cycle thru the available video inputs connected. The input selection

LED’s will show which input is directed to the OUTPUT connector.