Installation Guide

19
8. SEMI-AUTOMATIC FUNCTION WITH END OF COOKING TIME
Choose the function end of cooking (
button) and set the fi nal time with the +/- buttons. The symbols “A”
and the pot symbol appear. The oven is switched on. When the time coincides with the set time the oven is
switched off and the pot symbol disappears. The buzzer then sounds. The symbol “A” starts to fl ash.
9. AUTOMATIC FUNCTION WITH COOKING TIME AND END OF COOKING
Choose the function cooking time and set the required time with the +/- buttons. The symbol “A” appears.
The oven is switched on and the pot symbol appear. Wait a few seconds until the current time appears.
Set the end time using the end of cooking button , the approximate fi nal time appears on the display.
Use the +/- buttons to set the fi nal time actually required. The oven is switched off and the pot symbol
disappear. The pot symbol will appear again when the time coincides with the fi nal time minus the cooking time.
At the end of the automatic programme the symbol “A” starts to fl ash. The buzzer sounds and the oven and pot
symbol disappear.
10. MINUTE MINDER
Choose the timer function ( button) and set the required time with the +/- buttons. The bell symbol will
remain on for the duration of time set. At the end of this time the buzzer sounds.
11. BUZZER
The buzzer sounds at the end of the cooking time function and continues to buzz for 7 minutes. The buzzer is
silenced by pressing any of the buttons or .
The volume of the buzzer can be adjusted using the “-“ button without having fi rst selected any function.
There are three diff erent buzz volumes to choose from and their duration depends upon the length of time for
which the “-“ button is held pressed.
12. START OF A PROGRAMME AND CHECKING
Once a programme has been selected it starts after setting the time. The time remaining can be viewed at any
time by selecting the corresponding function again.
13. IDENTIFYING A PROGRAMMING ERROR
There is a programming error if the time indicated on the clock is between the cooking and end of cooking times.
The error is indicated by the buzzer sounding and the symbol “A” fl ashing.
14. CANCELLING A PROGRAMME
To cancel a programme select the manual function. At the end of the set programme this is automatically cancelled.
15. IMMEDIATE USE
A) If the display fl ashes read point B, otherwise go to point C.
B) If the display fl ashes the correct time has not been set or there has been a power failure. In this case, set the
correct time (see paragraph 5) and then go to point C.
C) Press the
and button simultaneously. Set the temperature (thermostat knob) and function (selector
knob) using the knobs on the appliance.