Use and Care Manual

 Maximum depth of cabinets installed above the cooking top to be no more

13 inches deep.

 Seal the cut surfaces with a suitable heat-resistant sealant to avoid swelling

caused by moisture.

 If during installation the seal around the frame does not sit flush within the

countertop at the corners, the corner radius (maximum 3/16" (4 mm) can be

carefully filed down to fit. The cooktop has a seal underneath to keep it

securely in position and water/debris from getting underneath cooktop base.

 Use the clips that are included to hold the base securely in place.

 Disconnect the cooktop from electrical supply if connected before attempting to

service or move it.

Installing the cooktop

 Remove the cooktop from its package and set aside all burners, burner caps

and grates.

 Lower it centrally into the cut-out. When

doing so, make sure that the seal under the

cooktop sits flush with the countertop on all

sides. This is important to ensure an effective

seal. Do not use sealant.

 Use the 4 supplied clips to secure the base with

the underside of the counter top.

 Take each clip and slide it into each slot on the cooktop base, then loosely

fasten the clips to the cooktop with a Philips screwdriver with the screws

provided. Once this is done you’re

now ready to secure the cooktop to

the underside of the cabinet.