Installation Guide

- 12 -
Before Use
This refrigerating appliance is not intended to be used as a built-in appliance.
Remove all of the packaging , including the
foam backing at the bottom of the unit and the
tape that fixes the shelves and door bins inside .
Place the refrigerator to a
proper position , and adjust the feet to level . It is recommended to
wipe out your unit with a warm soapy cloth and dry it thoroughly before use .
Place the refrigerator and adjust to level , clean it , let the refrigerator stand for above 4-6
hours , and then
power the unit on . This helps make sure that the oil from the compressor has
settled properly , and will
help your unit run normally .
Water supply connection
WARNING: Connect to potable water supply only.
The water supply system
must be installed and connected by a professional technician.
When
using the function of ice maker, please make sure that the tap water pipe is connected normally
and
the water valve is opened. Enough space shall be reserved for the faucet connecting water source.
After the refrigerator operates stably, the ice maker will make ice. Upon power-on for the first time, cold
water is available after 5 hours since the refrigerator operates normally, and ice cubes or crushed ice is
available after 12 hours.
Starting
Connect the power cord , and turn on the power switch .
Upon startup for the first time, the screen
will display respective set temperature values
(the temperature of the fridge section is set to 41ºF(5°C), the temperature of
the freezer is
set to 0ºF(-18°C)).
The default mode
is energy saving upon startup: The screen displays for 20s and then goes
off. This mode to save energy and prolong the service life of LED lights.
Operation