Installation Guide

28
28
T
r
o
u
bl
es
h
o
o
t
i
n
g
T
ip
s
S
y
m
p
t
om
Poss
ibl
e
Ca
u
se
S
o
lu
t
i
on
BURNERS WILL
NOT LIGHT.
Burner parts or igniters
May be wet, dirty or
misaligned.
Check that the burner parts are clean,
dry and correctly assembled. Check
that the igniters are clean and dry.
TOP BURNER WILL
NOT STAY LIT
Failed thermocouple Replace thermocouple
FLAMES DO NOT
BURN ALL AROUND
THE
BURNER CAP.
Burner parts may be dirty
or misaligned.
See “Care and Cleaning” instructions.
BURNER FLAMES
ARE VERY LARGE
AND YELLOW.
Burner bezel ports
are clogged.
Burner ports or burner
caps are not positioned
properly.
Range top is being
operated with the wrong
type of gas.
Regulator is not
installed, is faulty, or is
set for the wrong type of
gas.
Clean burner bezel ring ports with
straightened paper clip, needle, or wire.
Remove and carefully re
‐
install
burner bezel and caps.
Ensure that the type of range top
matches the gas supply.
Check installation, replace
regulator, or set regulator for proper
gas.
IGNITERS ARE
SPARKING BUT
BURNERS ARE NOT
IGNITING.
Gas shut‐off
valve is in the
“OFF” position.
Turn shut‐off valve to the “ON”
position.