Specifications

Hallowell



Premium KD

Stock Wardrobe and Box Lockers

General: Lockers shall be "Premium KD Wardrobe and Box Lockers" as manufactured by Hallowell or

approved equal. Fabricate lockers square, rigid and without warp, with metal faces flat and free from

dents or distortion. Make all exposed metal edges safe to touch. Weld frame members together to

form rigid, one-piece structure. Weld, bolt, or rivet other joints and connections as standard with

manufacturer. Grind exposed welds flush. Do not expose bolts or rivet heads on fronts of locker

doors or frames except for fastening of number plates and recessed handle.

Lockers shall be GREENGUARD Children & Schools Certified

Finishing: All locker parts to be cleaned and coated after fabrication with a seven stage zinc/iron

phosphate solution to inhibit corrosion, followed by a coat of high grade custom blend powder

electrostatically sprayed and baked at 350 degrees Fahrenheit for a minimum of 20 minutes to provide

a tough durable finish.

Color: Parchment, Hallowell Gray, Marine Blue, Maroon, and Green Mist colors are available for Stock

lockers. Parchment, Hallowell Gray and Marine Blue lockers include matching body colors. Maroon and

Green Mist lockers include Parchment body and sides. Some sizes and models are available in limited

colors.

Frame: Fabricate of 16 gauge (minimum) channels, with integral continuous door stop/strike formed

on both latch and hinge side vertical members. Cross frame members of 16 gauge channel shapes,

including intermediate cross frame members on double and triple tier (frames with doors over 18"

high) lockers shall be securely welded to the vertical framing members to ensure rigidity. Rubber

bumpers shall be provided to cushion door closing.

Premium KD Wardrobe Doors: Doors 20" high and over to be fabricated from single sheet prime 16

gauge (18 gauge for doors 9" wide as well as Two-Person and Duplex doors) with single bends at top

and bottom and double bends at the sides. The channel formed by the double bend at the latch side

is designed to fully conceal the lock bar. Doors shall be louvered. Upper compartment doors of Two-

Person shall be plain (non-louvered).

Premium KD Box Doors: Doors 18" high and under to be fabricated from single sheet prime 18 gauge

with single bends at top, bottom and sides. Doors shall include a combination friction catch door pull.

Padlock Strike Plates are optional. Doors shall be fabricated to accept a built-in combination lock or

padlock. Doors with projecting spring latches shall not be acceptable. Doors shall be louvered.

Stainless Steel Recessed Locker Handle: All wardrobe doors shall have a seamless drawn recessed

stainless steel handle shaped to receive a padlock or built-in combination lock. The recess pan shall be

PAGE 1
Hallowell Premium KD Stock Wardrobe and Box Lockers General: Lockers shall be "Premium KD Wardrobe and Box Lockers" as manufactured by Hallowell or approved equal. Fabricate lockers square, rigid and without warp, with metal faces flat and free from dents or distortion. Make all exposed metal edges safe to touch. Weld frame members together to form rigid, one-piece structure. Weld, bolt, or rivet other joints and connections as standard with manufacturer. Grind exposed welds flush.
PAGE 2
deep enough to have the lock be flush with the outer door face. Box doors shall be equipped with a combination friction catch door pull as stated above.
PAGE 3
Hallowell Premium KD Wardrobe and Box Lockers (Page 2) Latch Assembly: The latching mechanism for wardrobe doors shall be finger lift control type constructed of 14 gauge (minimum) steel with a nylon cover that has a generous finger pull. Spring activated nylon slide latches shall be completely enclosed in the lock channel allowing doors to close with the lock in the locked position. Locking devise shall be designed for use with either built-in combination locks or padlocks.