Instruction Manual

5. Once you have set the minutes and pressed the M-button the date and time

are set and the time is displayed.

- If no button is pressed for 20 seconds, the thermometer automatically

switches to the measuring screen and you are ready to take a reading.

- To cancel time setup, press the button during time setup. The LCD will

show Date / Time icons with “--:--”. Press the Power button to start

the measurement. If no further action is taken within 60 seconds, the

thermometer will automatically turn OFF.

- If the time and date need to be changed at a later time, press and hold the

M button, while the thermometer if OFF, until the year digits start to ﬂash.

Follow steps above to update the time and date.

6. Directions For Use

PLEASE NOTE: When you turn the thermometer on by

pressing the button, all segments of the screen will be

shown for 1 second and one beep is heard. (Figure 1)

1. When the thermometer is ready to take a reading the °C

or °F icon will be ﬂashing, and you will see -- - on the screen.

2. Straighten the ear canal by gently pulling the middle of the ear back and up.

3. Place the probe ﬁrmly into the ear canal, press the START button and keep

the probe in the ear until the thermometer beeps to signal the completion of

the measurement. The probe LED light will turn OFF once the START button

is pressed to take the measurement.

7. Setting The Beeper

1. When the thermometer is OFF, press and hold the button

for 5 seconds to set the beeper.

2. Press the

button again to either turn the beeper ON or OFF.

The beeper is activated when the beeper icon is not crossed

out. (Figure 2)

NOTE: If no button is pressed for 5 seconds, the thermometer

automatically switches to measuring mode.

Figure 1

Figure 2