Instructions / Assembly

ENGLISH

LIGHT STAYS ON

LIGHT COMES ON

RANDOMLY

Is the light sensor in a shaded area?

• Shine a flashlight into the light sensor for 2-3

minutes. If the light turns off, the fixture is

mounted in an area that does not allow enough

light to enter the light sensor.

Is the light sensor good?

• Shine a flashlight into the light sensor for 2-3

minutes. If the light does not turn off, the light

sensor is bad. Call customer service.

LIGHT COMES ON FOR

ONLY A FEW SECONDS

Is the light sensor sensing reflected light?

• Cover light sensor with electrician’s tape. Wait 2-3

minutes to see if light turns on. If it does, fixture is

receiving reflected light. Partially cover the light

sensor to block out the reflected light.

Is there power to the fixture?

• Has the house circuit breaker tripped?

• Is the wall switch ON?

Is the bulb(s) plugged or screwed in completely?

• Is the bulb(s) good?

(Be careful not to over tighten.)

Is the light sensor able to determine darkness?

• Cover light sensor with electrician’s tape. Wait 2-3

minutes to see if light turns on. If it does, the

sensor is receiving too much light.

Is the wiring to the unit loose?

TURN OFF POWER BEFORE CHECKING.

LIGHT DOES

NOT COME ON

What to do if...

FW42PC_PCW 825-0142.qxd:FW Series 325-1094 Spreads.qxd 6/3/08 4:34 PM Page 5