Compatibility Chart

Dimmer Notes:

1) Start time is measured at the lowest dimmer setting.

2) Some LED dimmers have a "rapid start" design used to provide a momentary power boost to LED and CFL lamps during start-up.

When a LED luminaire is on a dimmer with "rapid start" the boost may cause a momentary ﬂash of the LED lighting. This "ﬂash"

is generated by the dimmer, and may be more noticeable when the dimmer is at a low setting. A solution is available with EATON

dimmers which provide adjustment capability of the "rapid start": Devine (DAL06P), Accell (AAL06P), and Trace (TAL06P). Refer to

product speciﬁcations online at www.eaton.com/lighting for more details.

Dimming Guide Disclaimer:

1) Leviton

is a registered trademark of Leviton Manufacturing Co. Inc.; Lutron

is a registered trademark of Lutron Electronics Co.

Inc.; Lightolier

is a registered trademark of Philips Lighting; Hubbell

is a registered trademark of Hubbell Incorporated; Legrand

and

Pass & Seymour

are registered trademarks of Legrand

. These companies and their tradenames, trademarks or brands, where noted,

are associated with their respective company and are not associated with EATON.



2) Testing conducted by EATON is not a substitute for and does not imply certiﬁcation by an independent laboratory or any other

standards certiﬁcation.Refer to the manufacturer speciﬁcations for more detailed information on product certiﬁcations and standards.

3) This is a representative list of typical dimmers as tested by EATON lighting solutions business for performance with the designated

LED luminaires only. Test data contained in this literature is based upon dimmers obtained in the marketplace.Information about

these other manufacturers products is obtained from packaging and published information made available by the manufacturer and is

deemed to be reliable, but has not been veriﬁed.Dimmer performance and perceived limitations of the dimmers are based on factors

outside of EATON's control.The speciﬁcations of these dimming controls and their conditions of use may change without notice to

EATON lighting solutions or any other user.EATON lighting solutions makes no speciﬁc recommendation on product selection and

there are no warranties of performance or compatibility implied. Installer must ensure proper local and national electrical codes are

followed; and that the dimmer application and condition of use is per dimmer manufacturer instructions and guidelines.

Eaton HLB Dimming Guide - PA518121EN