Instructions / Assembly

Skip this step if the housing is already equipped
with an orange quick connector. If installed:
Remove the mounting bracket and plate from
inside the housing and then remove the socket
from the plate. Then screw the Socket
Adapter (B) into the housing.
Plug the orange quick connect into
the light.
Skip this step if installing into a 6”
housing. For 5” housings: Loosen
screws on top brackets and slide
them into the 5” position & retighten
the screws.
Press both pairs of torsion spring
legs together and insert them into the
receivers inside the housing.
Setup and Control
DiYers & Homeowners: Configure and
control lighting quickly using the WiZ App.
Installers: Use the WiZ Pro Setup App for
initial claiming and configuration over
Bluetooth and to manage multiple projects.
Then control with advanced features using
the WiZ Pro Dashboard and WiZ App once
Wi-Fi is connected. For more information
visit: pro.wizconnected.com
2
5 6
3 4
INSTALLATIONS INSTRUCTIONS & MOUNTING
For ground connection, attach the
preinstalled green ground wire on
the light to the housing, using 1 of 3
connection methods:
i. Use sheet metal screw (B) to attach
to 1 of 3 slots inside housing.
ii. Drive pan head screw (C) into
existing hole inside the housing.
Note: If no hole exists, drill a
small [1/8”] pilot hole and use the
provided #8 sheet metal screw (B).
iii. Twist nut (D) onto the threaded stud
in housing wall.
Note: If no hole exists, drill a small pilot
hole and use the provided #8 sheet
metal screw.
1
#1
#2
#3
#1
#2
#3
#1
#2
#3
#1
#2
#3
#1
#2
#3
#1
#2
#3
ALTERNATE INSTALLATION - FRICTION CLIPS
Torsion Springs Method
1. Pull down firmly on the module
until it stops.
2. Reach between the flange of the
light (inside the can) and squeeze
legs together to remove the fixture.
3. Unplug the orange connector and
remove the ground wire.
Friction Clips Method
1. Twist the fixture (about 60°) coun-
terclockwise to release the grip of
the friction clips.
2. Pull down firmly on the fixture to
remove it from the housing.
3. Unplug the orange connector and
remove the ground wire.
Friction Clips Method
1. Unscrew the torsion spring brackets from the module and discard.
2. Insert friction clips into friction clip holders making sure that they are fully seated, and locking feature engages (indicated by a click).
3. Properly wire the unit as instructed in WIRING section of these instructions.
4. Make sure all 3 friction clips are full expanded by rotating the clips as shown.
5. Align the module in the center of the recessed housing and firmly press the light fixture upward into it.
Cooper Lighting Solutions
1121 Highway 74 South
Peachtree City, GA 30269
P: 770-486-4800
www.cooperlighting.com
© 2022 Cooper Lighting Solutions
All Rights Reserved.
Specifications and dimensions
subject to change without notice.
IL518126ML
April 26, 2022 9:45 AM
UNINSTALLING