Specification Sheet

26"
660mm
O
14"
356mm
(2 PL)
22"
559mm
8 - O.
500" HOLES
EQUALLY SPACED ON
TWO O12.00" B.C.
8"
203mm
6 9/16"
167mm
30"
762mm
10"
254mm
O
64"
1626mm
19"
483mm
44"
1118mm
14 9/16"
371mm
29"
737mm
27"
686mm
33 5/16"
847mm
10"
254mm
O
B
A
A
1-1/2" DRAIN
34 11/16"
881mm
ORIFICE
HEIGHT
O
10"
254mm
3"
76mm
*
Printed in the U.S.A.
Page 2
A = ACCESS PANEL (8” x 10”)
B = REMOVABLE BOTTOM COVER
Endura II™ Outdoor Tubular
Bottle Filling Station
MODEL 4420BF1UDBFRK
TOP VIEW
OPERATING PRESSURES:
Supply water 20 – 105 psi maximum
FRONT & SIDE VIEWS
MOUNTING INSTRUCTIONS and
PLUMBING INSTRUCTIONS
Site and drainage excavation is required for fountain installation. Refer
to owner’s manual for site preparation details. Provide solid, well-drained
surface to mount pedestal fountain (concrete pad recommended) with
adequate support (300 lb. load minimum). (8) 3/8” minimum fasteners
(not included) should be attached securely to mounting surface in order
to secure fountain, (Refer to rough-in diagram), and be sure to allow
an opening for the freeze-resistant valve in the ground as shown in the
installation instructions that accompany the fountain. (Refer to page 4 for
freeze resistant valve installation). NOTE: Pet Fountain will not be freeze
resistant. Refer to local codes for any additional requirements.
Locate and install plumbing through ground as required. Assemble
fountain to prepared site and mounting pad.
NOTE: Fountain is not furnished with service valve.
Position pedestal over plumbing and secure base to fasteners. Remove
access panels and connect supply and water lines. Turn on water supply
and check for leaks. Refer to owner’s manual for detailed instructions.
Reassemble access panels to pedestal.
Trap and service stop not included.
REFER TO PAGE 4 FOR
FREEZE RESISTANT VALVE INSTALLATION
NOTE: PET FOUNTAIN WILL NOT BE
FREEZE RESISTANT
* ADA Requirement
halseytaylor.com
HALSEY TAYLOR, 2222 Camden Court, Oak Brook, IL 60523
®