Installation Sheet

ManualsBrandsHalsey Taylor ManualsShop All Halsey TaylorHalsey Taylor OVL-II Wall Mounted Bi-Level Indoor/Outdoor Water Fountain Coolers - Barrier free with Vandal Resistant Bubbler

Page 5

98953C (Rev. B - 11/16)

HVR8BL(R)*1D HVR8BLWF*1D

IMPORTANT

ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON

HANGER BRACKETS & TRAP

INSTALLATION

1) Remove hanger bracket fastened to back of cooler by removing one (1) screw.

2) Mount the hanger bracket and trap as shown in Figure 2.

NOTE: Hanger Bracket MUST be supported securely. Add xture support carrier if wall will not provide adequate support.

IMPORTANT:

• 6 1/4 in. (159mm) dimension from wall to centerline of trap must be maintained for proper t.

• Anchor hanger securely to wall using all ve (5) 1/4 in. dia. mounting holes.

3) Install straight valve for 3/8” O.D. tube.

INSTALLATION OF COOLER

4) Hang the cooler on the hanger bracket. Be certain the hanger bracket is engaged properly in the slots on the cooler back as shown in Figure 2.

5) Loosen the two (2) screws holding the lower front panel at the bottom of cooler base and two (2) screws at the top (Use torx bits sold separately). Remove the front panel and

set aside.

6) Connect water inlet line--See Note 4 of General Instructions.

7) Remove the slip nut and gasket from the trap and install them on the cooler waste line making sure that the end of the waste line ts into the trap. Assemble the slip nut and

gasket to the trap and tighten securely. Recommend fastening cooler to wall using 7/16 bolt holes. (see g.2, “F”)

START UP

Also See General Instructions

8) Stream height is factory set at 45-50 PSI. If supply pressure varies greatly from this, adjust screw using the access hole in the pushbutton (insert screwdriver). CW adjustment

will raise stream and CCW adjustment will lower stream. For best adjustment, stream should hit basin approximately 6-1/2” (165mm) from bubbler.

Fig. 4

Filter Location - When Provided

Fig. 5

Filter - When Provided

DESCRIPCIÓN

ITEM

NO.

55897C

98926C

1000003563

Filtro CPL 1500 galones

Kit - accesorios de cabeza de ltro

Kit - ltro cabeza, soporte, accesorios/

agua-en tubo

DESCRIPTION

PART

NO.

Filtre CPL-1500 gallons

Kit - accessoires de tête de ltre

Kit - ltre tête/support/raccords/eau-en

Tube

DESCRIPTION

WATERSENTRY

FILTER PARTS LIST

(See Fig. 5)

LISTA DE PIEZAS DEL FILTRO

(Vea la Fig. 5)

LISTE DES PIÈCES DU FILTRE

(Voir Fig. 5)

Filter Assy-1500 Gallon

Kit - Filter Head Fittings

Kit - Filter Head/Bracket/

Fittings/Water-In Tube