Instructions / Assembly

ManualsBrandsHalsey Taylor ManualsDrinking FountainsNon-Filtered 8 GPH ADA Wall Mount Stainless Steel Bi-Level Drinking Fountain

Page 5 98945C (Rev. E - 03/18)

HACFSCDBL*E HACFSCDDBL*E HACFSCDDBLR*E HACFSCWFDBL*E HACFSCWFDDBL*E

HAC8FSCBLQ*1F HAC8FSCBLRQ*1F HAC8FSCWFBL*1F

COOLER BACK

SUPPORT DE SUSPENSION

ARRIÈRE DU REFROIDISSEUR

HANGER BRACKET

FIJADOR DE SUSPENSIÓN

SUPPORT DE SUSPENSION

PUSH BAR MECHANISM

IMPORTANT

ALL SERVICE TO BE PERFORMED BY AN

AUTHORIZED SERVICE PERSON

HANGER BRACKETS & TRAP

INSTALLATION

1) Remove hanger brackets fastened to back of cooler by removing one

(1) screw.

2) Mount the hanger brackets and trap as shown in Figures 2 or 3.

NOTE: Hanger Brackets MUST be supported securely. Add xture sup-

port carrier if wall will not provide adequate support.

IMPORTANT:

• 4 1/8 in. (105mm) dimension from wall to centerline of trap must be

maintained for proper t.

• Anchor hanger securely to wall using all ve (5) 5/16" dia.

mounting holes.

3) Install straight valve for 3/8" O.D. tube.

INSTALLATION OF COOLER

4) Hang the cooler on the hanger bracket. Be certain the hanger

bracket is engaged properly in the slots on the cooler back as

shown in Fig. 5.

5) Loosen the two (2) screws holding the lower front panel at the

bottom of cooler base and two (2) screws at the top. Remove the

front panel and set aside.

6) Connect water inlet line--See Note 4 of General Instructions.

7) Remove the slip nut and gasket from the trap and install them on

the cooler waste line making sure that the end of the waste line

ts into the trap. Assemble the slip nut and gasket to the trap and

tighten securely.

START UP

Also See General Instructions

8) Stream height is factory set at 45-50 PSI. If supply pressure varies

greatly from this, readjust stream height to approximately 1-1/2"

(38mm) above the bubbler guard by turning adjustment screw, ac-

cessible by removing front push panel. Item No. 16 (see Fig. 4 & 6).

9) Replace the front panel and secure by retightening four (4) screws.

10) If a taste, odor or sediment problem is prevalent, try installing our

water lter module.

FIG. 4

CORRECT STREAM HEIGHT

FIG. 5

FIG. 6

LEGEND

A) Note: Water ow direction

B) Adjust this screw to eliminate mechanism “Free Play” or continuous ow

from bubbler conditions. (See ADJUSTMENT PROCEDURE)

C) Stream height adjustment (see note #8)

Water Valve Mechanism - ADJUSTMENT PROCEDURE:

- Turn adjustment screw (Item 11) “Counter-Clockwise” until water ow from bubbler starts.

- Turn adjustment screw “Clockwise” until water ow stops, THEN turn an additional 1/2 turn.

NOTE: Adjustments stated above are viewed from underneath unit (bottom side of

dispenser panel Item 40)

NOTE: If continuous ow occurs at the end of the compressor cycle, turn cold control

(Item 29) counterclockwise 1/4 turn.

11 - B