Specification Sheet

Printed in the U.S.A.
HTICF
Ice Chilled
Drinking Fountain
(CONTINUED)
MOUNTING INSTRUCTIONS and
PLUMBING CONNECTIONS
Provide solid, well-drained level surface to
mount fountain (concrete pad optional).
One 36 inch mounting bolt (included) should be
attached securely to fountain base and mounting
surface as per instructions with hold down kit
included with fountain. Hold down kit contains
one mounting bolt (36" L x 1/2" D) and one
brace.(Refer to rough-in diagram).
Locate and install plumbing through ground as
required. NOTE: Fountain is not furnished with
service valve. Assemble mounting brackets to
pedestal base with bolts provided. Position
pedestal over plumbing and secure base to
anchor bolts. Open cabinet door and connect
water supply. Turn on water supply and check
for leaks. Stream height is factory set at 45-50
psi. If water pressure varies greatly from this,
adjust automatic stream regulator to provide
drinking stream approximately 1 1/2" above
projector guard.
Trap and service stop not included.
OPERATING PRESSURES
Supply water - 105 psi maximum.
17 1/2
444mm
42 5/16
1074mm
40 7/16
1027mm
10 1/2
10 1/2
4 1/4
17 1/2
17 1/2
FOUNTAIN BASE/ HOLD DOWN KIT
FRONT VIEW
SIDE VIEW