User Manual

118

Output Signal from the Motronic Sensor

Zero Volts

(Ground)

Output Signal Zero Volts

(Ground)

If the wires are reversed and the signal goes negative (-) first, or a rising edge is selected to

trigger the Haltech ECU, then the on-board reluctor adapter will still generate a pulse but it

will not trigger the Haltech correctly resulting in incorrect ignition timing. So please make

sure it is wired correctly.

E.2.3 Adjusting The On-Board Jumpers

• Remove the 4 phillips head screws from the endplate opposite to the main connector.

• Slide the lid off the enclosure.

JUMPER LOCATIONS

JUMPERS DIP SWITCHES

MAIN CONNECTOR

J11

J10