User guide

F10X Manual
110
E.2 Coil Negative Triggering
The F10X can be triggered by the signal found on the negative side of an Ignition Coil. The
F10X has a sole purpose input wire for this signal called “Negative Coil/Tacho Output” which
is Pin 36 on the F10X ECU. Please make sure that in the Trigger Setup page, the Trigger
Type is set to Coil Negative/Tacho Output if this type of trigger is to be used.
Below shows how the coil negative trigger wire should be connected.
F10X
ECU
+
_
IGNITION
COIL
Coil Negative/Tacho Output:
( Pin 36 on ECU)
Below is how to configure the Trigger Setup page for Coil Negative triggering
Coil
Ne
g
ative
/Tacho
Output
setting