Owner's manual

34
• Set Auto-check setting to YES to have the radio
automatically check for new softwareupdates at regular
intervals. (Recommendation)
• Choose Check now to manually start acheck for
softwareupdates.
Warning
• Make surethat the radio has astable power supply
beforeyou start asoftwareupdate.
• Power supply failureduring asoftwareupdate can
cause irreparable damage to the radio.
15.7 Setup wizard
Youcan restart the setup wizard(5.4.1. Setup wizard) at
any time by proceeding as follows:
[menu]
System settings

Setup wizard
15.8 Info
• To have the radio display current information about
its hardwareand software(version numbers, device
designation, radio ID, etc.), proceed as follows:
[menu]
System settings

Info
• If you have already registered your radio on the
online portal of Frontier Silicon
(http://www.wiradio-frontier.com), then you can
nd out the radio ID there, as well.
15.9 Backlight
The backlight can be congured for each operating
mode (Operation Mode, Standby Mode, Slumber Mode)
separately.
• Proceed as follows:
[menu]
System settings

Backlight
• Forthe operation modes Operation Mode and
Slumber mode,select between various brightness
levels.
• For Standby Mode,you may also choose abrightness
level for the backlight when the radio is in standby
(Standby Level).Alternatively,you can set the backlight
to turn off completely in standby (Standby Level 
Off).
• Choose atime interval for Timeout.When the radio is in
standby,press [enter/navigate]toilluminate the display
at the brightness level set for that operating mode for the
selected interval of time.
• Alternatively,you can disable this feature(Timeout 
Off).
Alternatively,press [ ]onthe remote control to directly
adjust the backlight setting for the current operating
mode.