User manual

Note –Capacity

•The capacity is always shown when the Power Pack is charging.

•Each status LED corresponds to 25% of the capacity.When an LED is permanently illuminated,

this indicates that this capacity level has already been reached. The Power Pack is charged to

at least 75% if three LEDs areilluminated, and the fourth is ashing.

•Ifall four status LEDs light up, the full capacity is available.

•Press the button of the Power Pack to switch it on and to check its current capacity.

•Toswitch the power pack off,press the button twice until the status LEDs go out.

Warnung –Battery

•D

onot char

ge the power pack using your PC or the notebook. The char

ging curr

ents can

damage the USB port of the PC/notebook.

•Only use suitable charging devices or USB connections for charging.

•Asarule, do not charge devices or USB connections that aredefective and do not try to repair

them yourself.

•Donot overcharge the product or allow the battery to completely discharge.

•Avoid storing, charging or using batteries in extreme temperatures.

•When stored over along period of time, batteries should be charged regularly (at least every

three months).

4.2 Charging terminal devices

•Connect the included Micro-USB charging/connecting cable to the USB port on the power pack

(OUT 5V/3A)and to the Micro-USB port on your terminal device (mobile phone, smartphone,

etc.).

•The Micro-USB charging/connecting cable included may not be suitable for the USB connection on

your terminal device. In this case, use the USB cable that was included with your terminal device.

•When using the USB Type-C output for charging, please connect asuitable USB Type-C charging

cable to the power pack’s(OUT 5V/3A)USB Type-C output and to the port of your terminal device.

•Charging begins automatically.The status LEDs show the remaining capacity when the Power Pack

is charging.

•The current battery status of your terminal device will appear on this device.

•Press the button on the power pack twice to stop charging and switch it off.The status LEDs

should switch off.

•The Power Pack will automatically switch off if it is not connected to aterminal device.

Warning –Connecting terminal devices

•Beforeconnecting aterminal device, check whether the power output of the charger can

supply sucient power for the device.

•Ensurethat the total power consumption of the connected terminal device does not exceed

3000

mA.

•Please refer to the instructions in the operating manual of your terminal device.

•Itisessential that you observe these specications and the safety instructions regarding the

power supply of your devices.

•The power pack must not be charged and discharged at the same time!