Operation Manual

Helpline 00800 31133113
14
Programming for AUX devices (only easytip M5)
The AUX option allows you to control an additional device with your easy-
tip.
By positioning the disk to point to DVD/AUX, you have the option to con-
trol a second TV set, video recorder or SAT receiver instead of a DVD play-
er.
To program your remote control for a second TV set, please proceed as
described in the programming instructions for television sets. However, you
must ensure that the rotary pointer is positioned at DVD/AUX.
For programming, please following the above instructions for quick setup.
PLEASE NOTE!
With manual code entry, all codes (TV, VCR, SAT and DVD) are permitted
for selection DVD/AUX.
However, the automatic code scan for DVD/AUX only searches for DVD
codes.
Programming your easytip with automatic code
scan
Important:
We recommend manually entering and trying all codes given for your
device before running an automatic code scan.
If the listed codes are not working for your TV set, etc., or if the manufac-
turer of your device is not listed, you have the option to let the remote
control find a suitable code by means of the automatic code scan. During
this procedure, every code is tested on your devise and a signal is sent
approximately every 2 seconds. As soon as a suitable code has been found,
the device will respond according to the key that has been pressed. You
must now test the other functions of your remote control. If some of them
appear not to be available, this might be due to the fact that only the first
of many matching codes has been detected so far. In this case, continue
with the code scan until a more suitable code is found. Please be patient,
as a great number of different codes must be tried out during the scanning
process. It might therefore take up to 8 minutes until the correct code for
your device is found.
User Manual