Operation Manual

Helpline 00800 31133113

How can I run a code scan for one manufacturer only (code

0021)?

To run a code scan that is limited to the codes of one speciﬁc manufactu-

rer, proceed as described for "automatic code scan" (see above chapter).

However, in this case enter code 0021 followed by the code of your device

manufacturer. This code is listed in the appendix of this manual.

IMPORTANT!

As soon as the red LED ﬂashes three times, the scan through the codes of

your manufacturer is completed. If your device has not yet responded, run

an automatic code scan.

Identifying the correct 4-digit code (after having run an

automatic code scan)

After using the automatic scan mode the remote will have selected a code

which is unknown to you. Its important to know which code has been

found so that it can be reinstalled should something happen to the remote.

Please follow the steps below.

Step 1 Select the device that you wish to control with your easytip by

turning the disk until the arrow points to the desired device.

(only for M2

TV/VCR

, M2

TV/SAT

, M2

TV/DVD

and M5)

Step 2 Press the key until the LED ﬂashes twice (after approx. 2

seconds).

Step 3 Within 5 seconds enter code 0030. The red LED ﬂashes twice,

indicating that the remote control is now in "code identify

mode".

Step 4 To identify the currently saved code, press the following keys:

for ﬁrst digit

for second digit

for third digit

for fourth digit

These keys must be pressed in the above sequence. After each

digit key has been pressed, count the number of times the red

LED ﬂashes. To repeat the reading procedure, press any of the

four keys again within 5 seconds. Repeat the reading until you

are sure that you have the correct code written down.

When reading the code, also include the initial ﬂash of the LED

upon the pressing of keys into your count.

PLEASE NOTE!

If the LED does not ﬂash after you have pressed one of the above selection

keys, the respective code digit is 0.

User Manual