Use and Care Manual

5
How to Use
w WARNING
Cut and Crush Hazard.
Unplug mixer before inserting or removing attachments. Failure to do so
can result in broken bones or cuts.
2
3
4
6
BEFORE FIRST USE: Wash bowl and attachments
in warm, sudsy water; rinse and dry. Always
unplug before inserting or removing attachments.
1. Always make sure mixer is unplugged and
speed control is set to OFF ( ).
2. Press head tilt button to lift
mixer head.
3. Place bowl on bowl rest
and turn clockwise until it is
locked in place.
4. Push attachment up onto attachment shaft
and turn clockwise.
5. Press tilt button and lower mixer head down.
w CAUTION
Pinch Hazard.
Do not place fingers in hinge area.
NOTE: Attachment must be in place before
adding the splatter shield. Use the splatter
shield when making thin batters or mixtures
that will splash.
6. To avoid splashing ingredients out of bowl,
slide splatter shield over bowl until it rests
on bowl.
7. Plug into outlet.
8. Speed control should always be set on OFF
( ). Gradually turn dial to desired speed.
9. When finished, turn dial to OFF ( ).
10. Unplug. To remove splatter shield, lift up and
pull out. Press tilt button to lift mixer head.
11. To remove attachment, turn
counterclockwise and pull straight down.