Quick Guide

14. Found New Hardware Wizard: select «No, not this time» and click
«Next»
15. Found New Hardware Wizard: select «Install the software automati-
cally (Recommended)» and click «Next»
16. Depending on the Windows
®
Security Settings of your computer,
a Windows
®
Message «Hardware Installation» may pop up, click
«Continue Anyway» or «Install»
17. Found New Hardware Wizard: click «Finish»
NOTE: For optimum wireless trace performance in the
«continuous mode» of the HDM:
• Avoid operating any other Arc Wireless Conve
rter BT or View
(Ex) Handheld in the environment
• Place the Wireless Converter BT as close as possible to the
sensor to be traced
• Reduce the sampling rate of the trace file to a
useful value
• Avoid operating more than 30 sensors in the wireless range of
the Wireless Converter BT
LED status on the Wireless Converter BT
Software/hardware error
Ready to operate
Read/write status
How to install Arc Wireless Converter BT
1. Download Zip File «ArcSensorDTM_Setup.msi» from the Hamilton
web site www.hamiltoncompany.com
2. Do not plug in any converters to the computer USB port before you
have finished the ArcSensorDTM_Setup.msi
3. Depending on the Windows
®
Security Settings of your computer, a
Windows
®
Message «Open File – Security Warning» may pop up,
click «Run»
4. Welcome Screen: click «Next»
5. License Agreement: select «I accept» and click «Next»
6. Installation Folder: accept the default by clicking «Next»
7. Ready to Install: click «Install»
8. Depending on the Windows
®
Security Settings of your computer,
a Windows
®
Message «Hardware Installation» may pop up twice,
click «Continue Anyway» or «Install»
9. Completing Screen: click «Finish»
10. FTDI CDM driver Windows
®
: click «Extract»
11. Welcome Device Driver Installation Wizard: click «Next»
12. To complete the Device Driver Installation Wizard:
click «Finish»
13. Plug in your converter to the USB-port of your computer
> For Windows
®
7 the driver installs automatically
> For Windows
®
XP follow the next steps
Wireless Converter BT Quick Guide
NOTE: This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
NOTE: Changes or modifications made to this equipment not
expressly approved by Hamilton may void the FCC authorization
to operate this equipment.
Hamilton
HVIN: 243499/242333
FCC ID: 2AQYJARCWICONVBT
IC: 24225-ARCWICONVBT
This device complies with Part 15 of the FCC Rules and with Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.