Operating Instructions
Table Of Contents
- 1 General Information
- 2 Liability
- 3 Safety Precautions and Hazards
- 4 Product Description
- 5 Installation
- 5.1 Unpacking
- 5.2 Configuring the VisiTrace mA with ArcAir Application
- 5.2.1 Installing ArcAir Basic on the Computer
- 5.2.2 Connecting the VisiTrace mA Sensor to ArcAir
- 5.2.3 Create User Accounts
- 5.2.4 Configuring the VisiTrace mA Sensor Parameters
- 5.2.5 Configuring the calibration settings
- 5.2.6 Configuring the temperature settings of SIP / CIP process
- 5.2.7 Configuring the analog interface for your process control system
- 5.2.8 Defining a measuring point name for identification of the process
- 5.3 Install VisiTrace mA in your Measuring Loop
- 6 Operation
- 7 Maintenance
- 8 Troubleshooting
- 9 Disposal
- 10 Bluetooth Certification
- 11 Ordering Information
33Operating Instructions VisiTrace
™
mA Sensors
ORDERING INFORMATIONORDERING INFORMATION
NOTE: This equipment has been tested and found to
comply with the limits for a Class A digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.
NOTE: Changes or modifications made to this equip-
ment not expressly approved by Hamilton may void the
FCC authorization to operate this equipment.
11 Ordering Information
Parts below may only be replaced by original spare parts.
11.1 VisiTrace mA
*The VisiTrace mA 225 have, in reality, a shaft length of 215 mm.
This ensures optimal rinsing in retractable armatures, such as Retractex.
10068709 VisiTrace mA
Code Interface
1 mA/HART
Code Sensor Length in mm
1 120
2 225*
3 325
4 425
Code Cap
1 L0
Code Wetted parts
1 EPDM
10068709 – Orderingcode