User Manual

10 6.0 AMP RECIPROCATING SAW

OPERATING INSTRUCTIONS

3. Pivot Shoe Adjustment

Your tool is equipped with a pivot shoe that

can slide in and out to adjust the effective

stroke length for maximum control and

longer blade life.

a. Unplug the reciprocating saw from

the power source.

b. Loosen the shoe-release screws by

turning them counterclockwise with

the hex key (supplied) and slide the

shoe to the desired position.

c. Tighten the shoe-release screws by

turning them clockwise with the hex

key (supplied) to lock the shoe in the desired position.

WARNING: To avoid injury and damage, do not operate the saw without the

pivot shoe in place. The blade clamp may strike against the workpiece and damage the

reciprocating mechanism.

WARNING: Make sure that the front end of the blade extends through the shoe

for the entire stroke length. Do not use specialty blades that are very short or those with

signicant tilt. The blade must not contact the shoe. A blade that is too short or is tilted

could jam inside the shoe and then snap.

4. Pivoting the Shoe

The shoe pivots to provide maximum

control when it is aligned against the

surface being cut.

a. Unplug the reciprocating saw from

the power source.

b. Firmly hold the saw and then pivot

the shoe to the desired angle, while

taking care to avoid contact with the

blade.