Data Sheet

(5)
3M
™
Bumpon
™
Protective Products
Molded Shapes - Colored and Clear Series
SJ5000 • SJ5300 • SJ5400 • SJ5500 • SJ5700 • SJ6100
Relative Adhesive Performance Characteristics
Note: The following technical information and data should be considered representative or typical only and should not be
used for specification purposes.
3M™ Bumpon™ Protective Products
SJ5000
SJ5500 SJ5300
SJ5700 SJ5400 SJ6100
Adhesive: Natural Rubber Acrylic Synthetic Rubber
R-30 A-20 R-25
Initial Adhesion
Low Surface Energy: Good Poor Excellent
High Surface Energy: Good Fair Excellent
Adhesion (Peel)
Low Surface Energy: Good Poor Excellent
High Surface Energy: Good Good Excellent
Static Shear
75°F (25°C): Excellent Excellent Excellent
120°F (49°C): Good Excellent Good
158°F (70°C) Poor Excellent Fair
Dynamic Shear: Good Excellent Good
Solvent Resistance: Good Excellent Good
Adhesive Performance
Note: The following technical information and data should be considered representative or typical only and should not be
used for specification purposes.
The following table on peel adhesion provide representative performance characteristics of the adhesive systems
used in the construction of 3M™ Bumpon™ Protective Products molded series products.
90° Peel Adhesion *Peel Force, oz. Per 1/2 inch
3M™ Bumpon™ Protective Products
SJ5000
SJ5500 SJ5300
SJ5700 SJ5400 SJ6100
Substrate: Natural Rubber Acrylic Synthetic Rubber
R-30 A-20 R-25
Polypropylene 25 3 52
Polystyrene 25 11 55
ABS 25 25 55
Stainless Steel 22 25 55
Aluminum 22 25 55
*3M Test Method TM-2011; 72 hour dwell, 1/2 inch wide samples pulled at 12 inches per minute. Testing completed using Bumpon Resilient Rollstock
products SJ5816, SJ6016, and SJ6216, which use the same adhesive system as the molded series products.