User Manual

Hook-Up

CONNECTING THE LESLIE SPEAKER

An 8-pin type Leslie speaker can be directly connected to this keyboard.

 Switch keyboard OFF before connecting the Leslie speaker.

BASIC CONNECTION OF THE LESLIE SPEAKER

Connect the Leslie Speaker #2101, or #2101mk2 and the Leslie 8-PIN jack on this key-

board with the exclusive 8-pin Leslie cable (optional LC-8-7M, not included).

NOTE: The Leslie terminal on this unit is of 8-pin speci cations. Use the Leslie adaptor XLD-811

(optional) to connect a 11-pin spec. Leslie speaker e.g. #122XB.

1. Make the setting of Tone-Wheel organ.

2. Switch “ON” the [BYPASS] button, set the [STATIONARY VOLUME] of the

#2101/mk2 at desired volume.

3. Repeat “ON/OFF” the [BYPASS] button with playing the keyboard, set the [RO-

TARY VOLUME] of the #2101/mk2 at same volume which you can hear.

MIDI CONTROL OF THE LESLIE SPEAKER

To control the parameters of the Leslie Speaker #2101, #2101mk2 (ﬁ ne adjustment of

the rotor speed or the rise time, etc.):

1. Connect the MIDI OUT of this unit with the MIDI IN of the Leslie speaker with a

MIDI cable.

2. Set the keyboard channel - UPPER and the Leslie MIDI channel to the same chan-

nel. (P. 109)

When this unit detects that the Leslie speaker is connected, the Leslie parameters sent

through MIDI from this unit are switched from the XK-1C original to those for the

Leslie speaker.

LESLIE SPEAKERS TO BE CONNECTED

This keyboard is designed to connect with

3 channel Leslie speakers such as the model

#2101. However, it is also possible to connect

1 channel type Leslie speakers such as #3300

sending the stationary channels to the LINE

OUT jacks independently. (P. 80)

LESLIE CHANNEL

3 channel type Leslie speakers are equipped

with a stereo speaker system, independent of

the rotor, to provide direct organ sounds.

A traditional 1-channel Leslie, such as a #122

or #147 has no stationary speaker system, re-

quiring a separate ampli er/speaker for the

direct organ sounds.

8-pin Leslie Cable

MIDI Cable (Optional)