Operation Manual
114
*#1 $OM%OM$2OMOwner’s Manual
UTILIZING NEW FUNCTIONS & FEATURES
How to control the leakage sound:
The leakage volume of the whole tone-wheel set currently selected is adjustable by the LEAKAGE Pa-
rameter in the DRAWBAR Function mode. (P. 72 #2)
Adjustment of the leakage interval and or volume per each wheel can be made by using the Custom
Tone-wheel. (P. 92)
How to turn on PEDAL SUSTAIN:
Press [PLAY] and display “P.SUS”, then select “ON” by [VALUE]. The length of sustain effects is
controlled by the SL parameter in the DRAWBAR function mode. (P. 73 #8)
How to record other parameters than drawbars to the preset keys:
The memory/record operation on this organ also enables you to record various parameters along with the
Drawbar registrations. To set the parameter to call when the preset key is selected, set the parameters on
the P. LOAD page in the PRESET function mode. (P. 76)
How to see the actual values of a preset:
In case the physical location of the controller and the actual value do not exactly match when you call a
preset such as the [VIBRATO] tablet, you can display the actual value by operating the controller hold-
ing down the [PLAY] button. (P. 78) The actual Drawbar registration is displayed in PLAY mode.
How to locate each function mode easily?
You can “short-cut” to each function mode by moving some controllers (e.g. tablets, knobs) while press-
ing the [MENU/EXIT] button.
How to adjust the Drawbar settings while playing with the Preset C< - A:
To temporarily adjust the Drawbar settings while you are playing with the preset keys [C<] - [A], operate
Drawbars holding down the [PLAY] button. (P. 52)
Relation between the built-in Leslie effect and the external Leslie speaker:
If no Leslie speaker is connected or headphones are used while a Leslie speaker is connected, the built-
in Leslie effects are added to both (L & R) channels.
If a Leslie speaker is connected, the built-in Leslie effects are added only to the L channel.
How to avoid adding Leslie effects on the Pedal part:
The Pedal Part sound is independently output at the PEDAL OUT jack. The built-in Leslie effects,
Reverb, Tube Buffer do not function at this jack.
By connecting the PEDAL OUT jack and the PA equipment and setting the SYSTEM-PEDAL PART
OUTPUT parameter to “PEDAL”, the manual part and the pedal part are separately output to the Leslie
speaker and the PEDAL OUT jack respectively (P. 96 #1).
How to change the motion of the built-in Leslie effect when the Leslie mode
switch is set at “STOP”.
The default setting of the built-in Leslie effects on this organ is to bypass (thru) when the Leslie mode
switch is set at “STOP”, so you can enjoy the sound engine’s original sound.
To get the effect of the rotor stop of the Leslie speaker at this time, set the STOP mode at “STOP” in the
LESLIE function mode. (P.86 #20)
How to totally cut off the sound when the expression pedal is returned.
The characteristic of the Expression Pedal can be freely changed.
To turn off the sound completely when the Expression Pedal is returned, set all the minimum level, limit
LF, limit HF at “OFF” in the CONTROL function mode. (P. 91 #5, #6, #7)