Operation Manual
36
*#1 $OM%OM$2OMOwner’s Manual
How to power on
Back-Up
1. Set the [MASTER VOLUME] Knob at minimum.
2. Switch on the power of any external effects devices.
3. Turn on the [POWER] switch of the organ. The pilot lamp will light up and the PLAY
mode (fig.) is displayed, following the title. The Leslie Speaker is automatically turned on
simultaneously, if connected.
It takes a few seconds to reach play mode, because of the circuit-protection
devices.
The tubes require 10 to 20 seconds to warm up.
4. Turn on the power of the amplifier etc., if any connected to the LINE OUT.
5. Holding down a key, adjust the [MASTER VOLUME] by turning the Knob.
The Preset Key [B] does not produce sound when intially first turned on. Draw
the B Drawbars, or press either of the Preset Keys [C
<
] - [A] to start.
6. Adjust the volume of the amplifiers etc.
Reverse the above steps when you switch off the power. (Switch off the power
of the amplifiers etc. first.)
After connecting your organ to the power outlet, please follow this procedure before switching on
the power. To avoid possible damage to your speakers, please follow this procedure exactly.
Reset to the initial status
To reset the organ to the initial default setting:
1. Switch off the power of the organ.
2. Holding the [RECORD] button, switch on the power.
3. Keep pressing the [RECORD] button until “Loading Default...” appears on the
display.
4. When the reset is complete, PLAY mode appears on the display. (Completed)
This organ memorizes the settings of the parameters immediately before it is switched off. The organ
will start with these settings when it is switched on again.
POWER ON