Operation Manual

*#1 $OM%OM$2OMOwner’s Manual

LESLIE

CONCEPT OF THE CABINET NUMBERS

Each Cabinet represents one virtual Leslie Speaker pre-

pared by the Leslie Parameter.

This parameter is the only Preset Parameter in this

mode.

CABINET NUMBERS

1. CABINET NUMBER

Here you select the CABINET NUMBER to use in the Combination Presets.

The setting range is 1 - 8. The “*” will be displayed when the Leslie Parameters are

changed from this Cabinet Number.

LESLIE PARAMETERS

2. CABINET NAME

This is for assigning the Cabinet Names.

Move the cursor by the [PARAM] button and select letters by the [VALUE] button.

In this mode, only the present value “Temporary” changes and there is no determining

operation. You must record the name by doing “Recording the Cabinet” as explained in

the next paragraph. Otherwise the data will be lost.

3. AMPLIFIER

This sets the type of the virtual power amplifier.

SolidSolid

Solid: Simulated Solid-State Amplifier with a flat characteristic

ubeube

ube: Simulated Tube Amplifier with a warm characteristic.

In this mode, you make the settings for the built-in Leslie Effect.

There are many parameters for the built-in Leslie Effect. These

individual settings are not recalled by the Combination Presets,

or by bank settings. The built-in Leslie parameters are grouped

in macro-settings called “CABINETS”. You select the CABI-

NET NUMBER in the Combination Presets where this selection

is saved as part of the Preset.

To locate this mode:

1. Press the [MENU/EXIT] button to display the MENU. Then

select PAGE B by the [PAGE] button and press [3] LESLIE.

2. Or, move Leslie Speed Switch pressing the [MENU/EXIT] but-

ton.

5 6 7 8 9 10 11

12 13 14 15 16 17

18 19