Operation Manual

HA<O>
Sk1
/
Sk2
Owner’s Manual
22
HOW TO POWER ON
After making the necessary connections, follow the procedures below for powering on
your SK1/SK2. Please be sure to adhere to the procedure, to prevent malfunction or
damage.
u PROCEDURES
1. Before switching the power ON, confirm the [MASTER VOLUME] knob is set to
minimum.
2. Switch ON the [POWER] (on the rear of this keyboard). e Title mode and then
the Play mode are displayed (as illustrated).
v For protecting the circuits, the keyboard is designed not to play immediately at
the power on (about 6 seconds).
3. Switch ON the connected amplifier etc.
4. Play a bit, raising the [MASTER VOLUME] knob to adjust the volume to your
needs.
v The [MANUAL] button does not sound in the default settings. Pull out the
Drawbars or select any of the FAVORITE [1] to [10] buttons to get sound.
5. Adjust the volume of amplifier etc.
v To turn OFF the power, do the above steps in reverse. (Switch OFF the amplier
etc. rst.)
BACK UP
is keyboard “remembers” the unit’s status immediately before the power is turned off,
returning the unit to that status upon the next power-on.
e status of the default settings are the same as when the [MANUAL] button is depressed.
RESET TO THE FACTORY SETTINGS
To reset all parameters of this keyboard to its default settings, perform the following steps:
uOPERATION PROCEDURES
1. Switch the [POWER] of this keyboard off.
2. Holding down the preset [RECORD] button, switch the [POWER] ON.
3. Keep holding down the button until “Loading Default...” is displayed.
4. When the Play mode is displayed, this operation is completed.
SWITCH ON
PHONES
USB
FLASH DRIVE
UPPER
PEDAL
LOWER
NUMBER NAME
PATCH
ENTER
VALUE
MENU/
EXIT
PLAY