Operation Manual
95
Setting the Parameters
uEFFECTS OF THE EXTRA VOICE SECTION
OVERDRIVE
⓬ OVERDRIVE - SWITCH
Turns the Overdrive effect of Extra Voice section “ON/OFF”.
NOTE: While this parameter is “ON”, the stereo sound of “Stereo Grand” etc. becomes monaural.
⓭ OVERDRIVE - DRIVE
Controls the distortion amount. e distortion becomes greater as the value is increased.
ere is no knob linked with this effect, different from the organ section, so the setting
is possible only in this mode.
⓮ OVERDRIVE - EXPRESSION
⓯ OVERDRIVE - PREAMP
e functions of these parameters are the same as those of the organ section.
MULTI-EFFECTS
⓰ EFFECT TYPE
and the other effect parameters
e functions of these parameters are the same as those of the organ section.
❹ ❺ ❻ ❼
❽
❺ DELAY - TYPE
Select the type of delay here.
MONO:
A simply delayed sound.
RtoL, LtoR:
The delay is alternated in the stereo eld. At RtoL the delayed sound comes from the right, and
at LtoR from the left. Your results may vary when used in a mono idiom, or through a Leslie
Speaker.
❻ DELAY - TIME
Adjusts the delay time. It is linked with the [EFFECT AMOUNT] on the top panel.
e setting range is 10 to 1000 ms.
❼ DELAY - FEED-BACK
Sets the repetition amount of the effect sound.
e setting range is 0 to 127. e repetition becomes greater as the value is increased.
❽ DELAY - MIX
Adjusts the volume balance between the “dry” and the effect sound.
e setting range is 0 to 127. At 0, only the “dry” is heard. e effect level becomes
greater as the value is increased. At 64 the ratio between the “dry” and the effect sounds
becomes 1:1. At 127 only the effect sound is heard.
Time
Level
Time
Level
L R
L R
L R
TYPE = PAN
TYPE = MONO
Mix
Original Signal
Eect Signal
Feedback
Delay Time
Delay
is is for adding echo effects.
NOTE: All the parameters in these modes
are Patch Parameters. They are re-
corded into the Patch.