Operation Manual

*#1 :-Owner’s Manual
20
HOW TO POWER ON
After connecting your XK-1 to the power outlet, please perform the following steps before switch-
ing on the power. To avoid possible damages to speakers, please do not change the order of the
steps.
STEPS TO TAKE
1. Set the MASTER VOLUME Knob at 0 (minimum), before switching the power on.
2. Switch on the POWER on the rear panel. “PLAY” Mode appears, following the TITLE, in the
Display window.
 It takes a few seconds before the XK-1 gets ready, because of the circuit-protection
devices.
3. Switch on the power of the amplifiers etc. connected to the XK-1.
4. Holding down a key, adjust the MASTER VOLUME by turning the Knob.
5. Adjust the volume of the amplifiers etc.
 Reverse the above steps when you switch off the power. (Switch off the power of
the amplifiers etc. first.)
BACK-UP
Your XK-1 memorizes the setting of the keyboard immediately before it is switched off. So, The
keyboard will start with these settings when it is switched on again. This is called “Back-up”.
The XK-1 is initially shipped from the factory with the Preset Button [ADJUST] in “pressed”
status.
 The Preset Button [ADJUST] does not produce sound when initially first turned on.
Draw the left Drawbar(s), or press either of the Preset Buttons [2] - [11] to start.
RESET TO THE FACTORY SETTINGS
Please perform the following steps to reset the XK-1 to the initial default setting.
STEPS TO TAKE
1. Switch off the power of the XK-1.
2. Hold the [REC/JUMP] Button, and switch on the power.
3. Continue to hold down / Keep pressing the [REC/JUMP] Button until “Loading Default...”
appears on the Display.
4. After 5 seconds if everything is in order, PLAY Mode appears on the Display. (Completed)
POWER ON