Operation Manual

*#1 :-Owner’s Manual
36
MATCH THE REGISTRATION TO DRAWBARS
If you recall the Combination Preset, the Drawbar Registration
is not physical but is replaced with the recorded/memorized
one. If you move any Drawbar at this stage, only the Footage
moved is changed.
To match only the Registration to the Drawbars while using the
DRAWBAR SELECT
content of the Combination Preset, keep depressing the Preset
Key for a while. The Combination Preset is recalled and then
the physical Drawbar Registration is reflected.
The Drawbar Select Button can be turned off by re-touching,
and the no works to tell the controlling Drawbars. This means
that you can make the new resistration while playing and
change it.
To match the registration, use the function below.
ASSIGN THE DRAWBARS FOR EACH PART
On this keyboard, there are 3 Parts: UPPER, LOWER and
PEDAL, and each of them has the corresponding Drawbars.
The manual on the keyboard is usually assigned to the UPPER
position. If you want to play the LOWER or PEDAL Part, use
the Split or Manual Bass functions, or connect a MIDI key-
board and assign each part.
There is one set of Drawbars on this keyboard, though this
keyboard has 3 Parts. Use Drawbar Select Buttons for assign-
ment of the Drawbars for each of the Parts.
The Drawbar Select Buttons [UPPER], [PEDAL], [LOWER]
are used for selecting “which Part the Drawbars will be
assigned to”.
Press and
Hold
Release
Touch again
Touch